Vanguard Heating VN6A, VN12 Operating Heater, For Your Safety Read Before Lighting

Page 12

OPERATING HEATER

12

FOR YOUR SAFETY READ BEFORE LIGHTING

!WARNING

If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

LIGHTING INSTRUCTIONS

1.STOP! Read the safety information above.

2.Make sure manual shutoff valve is fully open.

3. Turn control knob clockwise

Clockwise

to the OFF position.

Control Knob

OFF

PILOT

IGN

LOW

HIGH

Figure 13 - Control Knob In The OFF Position (Model VN12 Shown)

Image 12
Contents OWNER’S Operation and Installation Manual What to do if YOU Smell GASContents Safety Information Safety Information Local Codes Unpacking Product Features Safety DeviceProduct Identification Piezo Ignition SystemInstallation Items Check GAS TypeLocating Heater Installing Heater to Wall CeilingFloor Marking Screw LocationsInstalling Two Mounting Screws Folding AnchorPlacing Heater On Mounting Screws Connecting to GAS Supply Pressure Testing GAS Supply Piping System Checking GAS ConnectionsPressure Testing Heater GAS Connections Manual Shutoff ValveFor Your Safety Read Before Lighting Operating HeaterLighting Instructions Pilot To Select Heating Level Burner PatternsManual Lighting Procedure Inspecting BurnerTo Turn OFF GAS to Appliance Pilot Flame PatternCleaning and Maintenance Burner Flame PatternODS/PILOT and Burner Orifice CabinetTrouble Shooting Observed Possible Problem Cause RemedyCleaning Observed Possible Problem Cause Remedy Technical Service Ing statement atTop VN12Parts Under Warranty Parts Not Under WarrantyManual Shutoff Valve GA5010Parts List VN6AIllustrated Parts Breakdown VN12Warranty Information Limited Warranty Vanguard VENT-FREE Residential GAS Heaters