Jotul Comprehensive Guide on Blower Kit Installation

Optional Blower # 155620

CONNECT THE GAS SUPPLY TO THE

STOVE BEFORE INSTALLING THIS

BLOWER. IF NECESSARY, USE A 90°

ELBOW OFF THE GAS VALVE TO CREATE

ADEQUATE GAS LINE CLEARANCE.

BE SURE ALL WIRE CONNECTIONS

HAVE BEEN MADE BEFORE

CONNECTING TO POWER SUPPLY.

1.Unpack and check the contents of the blower kit. Contact your dealer if any damage is evident or parts are missing. See fig. 33.

2.Attach the Snapstat Bracket to the studs located underneath the stove in the middle of the firebox floor using the two M6 hex nuts and a 10 mm wrench. See fig. 34.

3.Attach the Blower to the stove with the screen opening to the rear using the two M6 flange head hex bolts as shown in fig. 35.

4.Attach either Snapstat wire connector to either Snapstat terminal. See fig. 35.

5.Install the Snapstat by sliding it all the way into the slot in the Snapstat Bracket as shown in fig. 34.

6.Connect the female Control Switch quick-connector to the male control switch wire harness already installed in the stove. See fig. 35.

7.Connect power cord to the nearest outlet.

„THIS BLOWER MUST BE ELECTRICALLY GROUNDED IN ACCORDANCE WITH LOCAL CODES OR, IN THE ABSENCE OF LOCAL CODES, WITH THE CURRENT ANSI/ NFPA 70, NATIONAL ELECTRICAL CODE OR CSA C22.1-CANADIAN ELECTRICAL CODE.

„THIS UNIT IS SUPPLIED WITH A THREE-PRONG (GROUNDING) PLUG FOR PROTECTION AGAINST SHOCK HAZARD AND SHOULD BE PLUGGED DIRECTLY INTO A PROPERLY GROUNDED THREE- PRONG RECEPTACLE. DO NOT CUT OR REMOVE THE GROUNDING PRONG FROM THE PLUG.

„ALWAYS DISCONECT THE POWER

SUPPLY WHEN PERFORMING ANY

SERVICE ON THE FIREPLACE

INSERT.

5

4

1 6

2

3

	7
Contents	Tools Required
1. Blower	• 10 mm wrench

2.Snapstat Wire Harness

3.Control Switch Wire Harness

4.Snapstat

5.Snapstat Bracket

6.M6 Flange Nuts, (2)

7.M6 x 12 Hex Bolts, (2)

Figure 33. Blower Kit Components

Snapstat

Bracket

Hex Head

Flange Nuts

Figure 34. Attach Snapstat Bracket.

20