Heat & Glo LifeStyle WS-250, WS-150 Glass Replacement, Door Handle Assembly

GLASS REPLACEMENT

1.	Remove door from stove and lay
	on a padded flat surface.
2.	Remove glass tabs (See figure
	25) and screws with a Phillips
	screwdriver (turn screws counter-
	clockwise).
3.	Lift glass frame pieces and glass
	out of the door frame.
4.	Lay new glass with fiberglass tape
	around it into the door frame, mak-
	ing sure the Heat-N-Glo logo reads
	correctly to the outside.
5.	Place glass frame pieces over the
	fiberglass tape on the edges of the
	glass. Be sure glass is centered
	in the opening (i.e., same space
	top and bottom, left and right	FIGURE 25
	sides).

6.Reinstall screws and glass tabs tight enough to hold glass and frame in place. DO NOT OVER-

TIGHTEN.

7.Check again for centering of glass in door frame, and give all screws a final tightening.

DOOR HANDLE ASSEMBLY

NOTE: Spring handle not included in door handle assembly. When replacing door handle, either use old spring handle or order new spring handle separately (See Figure 26).

FIGURE 26

23