VFSV-(16, 18, 24, 30) LIGHTING INSTRUCTIONS
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may result
causing property damage, personal injury or loss of life.
A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.
B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
•Do not try to light any appliance.
•Do not touch any electrical switch;
do not use any phone in your building.
•Immediately call your gas supplier from a neigh- bor's phone. Follow the gas supplier's instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it; call a qualified service technician. Force or attempted repair may result in a fire or explosion.
D.Do not use this appliance if any part has been under water. Immediately call a qualified service techni- cian to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
LIGHTING INSTRUCTIONS
Note: For easy access to valve for lighting pilot, remove branch log and middle log from burner assembly before lighting.
1.STOP! Read the safety information.
2.Push in gas control knob
slightly and turn clockwise 
to the “OFF” position. Do not force.
3. Turn gas flow adjustment knob clockwise 
either manually or with remote control to “OFF”.
4.Wait ten (10) minutes to clear out any gas. Then smell for gas, including
near the floor. If you smell gas STOP! Follow “B” in the safety information. If you do not smell gas, go to the next step.
5.Find pilot - the pilot is attached to rear of burner.
6.Turn gas knob counterclockwise 
to “IGN”.
7.Depress and turn gas control knob counterclockwise
to “PILOT”. A spark is produced when gas control knob is turned between “IGN” and PILOT”.
Repeatedly depress and turn gas control knob between “IGN” and PILOT” until pilot is ignited. Continue to hold the control knob in for about one (1) minute after pilot is lit. Release knob and it will pop back up. Pilot should remain lit. If it goes out, repeat steps 2 through 7.
•If the knob does not pop out when released, stop and immediately call your service technician or gas supplier.
•If the pilot will not stay lit after several tries, turn the gas control knob to OFF and call your service technician.
8.Attention! Gas control has an INTERLOCK latching device. When the pilot is initially lit and the safety magnet is energized (pilot stays on ) the INTERLOCK latching device becomes operative. If the gas control is turned to the “OFF” position or gas flow to the appliance is shut off, the pilot cannot be relighted until the safety magnet is
9.Turn gas control knob counterclockwise 
to “ON”.
10. Turn gas flow adjustment knob counterclockwise 
either manually or with remote control between “OFF” and “ON” to adjust flame height.
TO TURN OFF GAS TO APPLIANCE 
1. Turn gas flow adjustment knob clockwise | either | 2. Push in gas control control knob slightly and turn clockwise |
manually or with remote control to “OFF”. |
| to “OFF”. Do not force. |
Page 15 |