Empire Comfort Systems VFSR-16-3, VFSR-18-3 installation instructions Introduction, Accessories

Page 5

INTRODUCTION

IMPORTANT: Read all instructions carefully before starting installation. Failure to follow these installation instructions may result in a possible fire hazard and will void the warranty.

Save this manual for future reference.

Please read this manual before installing and using the appliance. Instructions to Installer

1.Installer must leave instruction manual with owner after installation.

2.Installer must have owner fill out and mail warranty card supplied with unvented room heater/vented decorative appliance.

3.Installer should show owner how to start and operate unvented room heater/vented decorative appliance.

Always consult your local Building Department regarding regulations, codes or ordinances which apply to the installation of an unvented room heater/vented decorative appliance.

This appliance may be installed in an aftermarket* manufactured (mobile) home, where not prohibited by state or local codes.

*Aftermarket: Completion of sale, not for purpose of resale, from the manufacturer.

This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible for use with other gases.

New Installation

VFSV Model - variable does not operate-ON is OFF/OFF is ON-wires into the back of receiver are reversed.

Solid-fuels shall not be burned in a fireplace where a vented decorative appliance is installed.

A vented decorative appliance must be installed only in a solid-fuel burning fireplace with a working flue and constructed of non-combustible material.

Any alteration of the original design, installed other than as shown in these instructions or use with a type of gas not shown on the rating plate is the responsibility of the person and company making the change.

Important

All correspondence should refer to complete Model Number, Serial Number and type of gas.

Attention: During initial use of log you will detect an odor as the log is cured.

Notice: During initial firing of this unit, its paint will bake out, and smoke will occur. To prevent triggering of smoke alarms, ventilate the room in which the unit is installed.

WARNING: This appliance is for installation only in a solid- fuel burning masonry or UL 127 factory-built fireplace or in a listed ventless firebox enclosure. It has been design certified for these installations. Exception: DO NOT install this appliance in

afactory-built fireplace that includes instructions stating it has not been tested or should not be used with unvented gas logs.

WARNING: Any modification to this unvented gas heater or its controls can be dangerous. Improper installation or use of the heater can cause serious injury or death from fire, burns, explosion or carbon monoxide poisoning.

Well Head Gas Installations

Some natural gas utilities use "well head" gas. This may affect the Btu output of the unit. Contact the gas company for the heating value. Contact the manufacturer or your gas company before changing spud/ orifice size.

ACCESSORIES

 

Description

Color

 

 

 

For use with VFSV and VFSR models

 

 

 

 

EK-1

Embers Kit

 

ELH-1

Fireplace Hood for Vent-Free Logs

Black

ELH-2

Fireplace Hood for Vent-Free Logs

Brass

For use with VFSR models only

 

 

 

 

FRBC

Battery Operated Remote Control

 

FRBTC

Battery Operated Remote Control with Thermostat

FREC

Electric Remote Control

 

FWS

Wall Switch

 

GWSG-T

Wall Thermostat, Millivolt

 

TMV

Wall Thermostat, Millivolt - Reed Switch

PRODUCT SPECIFICATION

 

 

 

 

Natural Gas

 

 

Propane Gas

 

 

 

 

Variable

 

Millivolt

 

Variable

Millivolt

 

 

 

Regulator pressure setting

3.5" W.C.

 

3.5" W.C.

 

10.0" W.C.

10.0" W.C

 

 

 

Gas inlet pressure

Max.

10.5" W.C.

10.5" W.C.

 

13.0"W.C.

13.0" W.C.

 

 

 

 

Min.

5.0" W.C.

 

5.0" W.C.

 

11.0" W.C.

11.0" W.C.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

BTUH

 

BTUH

 

Model

Gas

Valve Type

Max. Rate

Min. Rate

 

 

 

 

 

 

 

 

 

 

 

 

VFSV-16

Natural

 

Variable

 

25,000

 

17,500

 

 

 

VFSV-16

Propane

 

Variable

 

22,500

 

15,750

 

 

 

VFSR-16

Natural

 

Millivolt

 

25,000

 

17,500

 

 

 

VFSR-16

Propane

 

Millivolt

 

22,500

 

15,750

 

 

 

VFSV-18

Natural

 

Variable

 

32,000

 

19,000

 

 

 

VFSV-18

Propane

 

Variable

 

32,000

 

19,000

 

 

 

VFSR-18

Natural

 

Millivolt

 

32,000

 

22,000

 

 

 

VFSR-18

Propane

 

Millivolt

 

32,000

 

22,000

 

 

 

VFSV-24

Natural

 

Variable

 

36,000

 

20,000

 

 

 

VFSV-24

Propane

 

Variable

 

36,000

 

20,000

 

 

 

VFSR-24

Natural

 

Millivolt

 

36,000

 

25,000

 

 

 

VFSR-24

Propane

 

Millivolt

 

36,000

 

25,000

 

 

 

VFSV-30

Natural

 

Variable

 

38,000

 

20,000

 

 

 

VFSV-30

Propane

 

Variable

 

38,000

 

20,000

 

 

 

VFSR-30

Natural

 

Millivolt

 

38,000

 

26,000

 

 

 

VFSR-30

Propane

 

Millivolt

 

38,000

 

26,000

 

 

14008-0-0403

Page 5

Image 5
Contents Installation Instructions Table of Contents Carbon Monoxide Poisoning MAY Lead to Death Important Safety InformationDo not Tamper with Pilot Light Safety System LP-GAS Warning Odor Safety Information for Users of LP-GASIntroduction AccessoriesMake sure you have received all parts General InformationBefore you get started Provisions for Adequate Combustion & Ventilation AIR ClearancesClearances Fireplace Preparation Combustible MaterialInstalling Damper Clamp Figure Installing AS a Vented ApplianceBefore Fully Installing the Appliance GAS Supply Installing a New Main Gas CockPressure Testing of the Gas Supply System Placement of Glowing Embers and Lava Rock LOG Grate PlacementProper Installation Sequence Vfsr and VFSV-16, 18, 24, 30C FigureVariable Figure Millivolt Figure Operation INSTRUCTIONS/FLAME AppearanceWhat to do if YOU Smell GAS VFSR-16, 18, 24, 30 Lighting InstructionsVFSV-16, 18, 24, 30 Lighting Instructions Vfsr Pilot Pilot Flame CharacteristicsVfsv Pilot Correct Pilot Flame Pattern Incorrect Pilot Flame PatternTurn OFF Heater and Allow to Cool Before Cleaning Cleaning and ServicingVfsv WiringVfsr Heater produces a whistling noise when main burner is lit Gas odor even when control knob is in OFF positionNew Installation Appliance produces unwanted odorsCommon Parts Parts ListParts View HOW to Order Repair Parts Service Notes Service Notes Mail info@empirecomfort.com