Samsung SPD-2200 manual Getting started, Bracket Setup for Installation, Initial Setting

Getting started

Bracket Setup for Installation

Video Out

Alarm In 1

Alarm In 2

Alarm In 3

Alarm In 4

Alarm Out 1

Alarm Out 2

AC 24V Output (for Heater connection)

Mainframe 18PIN Connector

Initial Setting

●Communication Protocol Setting (Installation Bracket)

Select and set SW1 on the installation bracket for setting the communication protocol.

SW1	Protocol	Baud Rate (BPS)
0	Samsung	9,600
1	Samsung	19,200
2	Pelco-D	2,400
3	Pelco-D	4,800
4	Pelco-D	9,600
5~F	Reserve

Note) Factory Default : 0 (Samsung, 9600)

●Baud Rate Setting by DVR Model

For control of the speed dome camera using DVR without a dedicated controller, set the baud rate by DVR model as described below.

Protocol	Samsung	Pelco
DVR Model
SVR-430	9600,19200	9,600
SVR-900/1620	9600,19200	4800, 9600
SVR-1630	9600,19200	2400,4800,9600

Note) A faster rate may degrade stability.

The control function may not be available depending on the DVR Firmware version.

Be sure to install the latest DVR Firmware version.

● Camera ID Setting (Mainframe front panel)

·Set the Camera ID using the two rotary switches. SW1 and SW2
refer to the lower and upper positions, respectively.
	SW2	SW1
·EX) If the camera ID is number 1, set as described below.	0	1
	SW2	SW1

ENGLISH

12 SPEED DOME CAMERA SPEED DOME CAMERA 13