Meyer woodchuck, 526, 2900, 4000 manual Operation, Common Sense, If You Have Chimney Fire, Danger

Page 9
OPERATION

OPERATION

COMMON SENSE

Please read the following before firing your furnace. It is most important that you follow these suggestions and limitations in order to maintain your warranty and guar- antee the long life of your furnace.

NOTE: Smoke detectors and fire extinguishers should always be a part of your equipment.

This furnace is an airtight unit designed to burn 6-8 hours per load of wood or coal. If the furnace is being fired hot constantly with full flames and operating at only 2-4 hour burn cycles, it may be over fired. Your home heating needs may be too great for the size of furnace you have purchased. Your furnace can be dam- aged if fired at extremely high temperatures.

Forced firing or abuse can be detected upon inspection

AND WILL VOID YOUR WARRANTY.

COMMON SENSEDANGER:

RISK OF FIRE OR EXPLOSION. DO NOT BURN GAR- BAGE, GASOLINE, DRAIN OIL, OR OTHER FLAMMA- BLE LIQUIDS. FAILURE TO HEED MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH.

! IF YOU HAVE CHIMNEY FIRE !DANGER:

NEVER USE CHEMICALS OR FLUIDS SUCH AS GASOLINE, CHARCOAL LIGHTER FLUID, DRAIN OIL, FUEL OIL OR KEROSINE TO LIGHT A FIRE IN YOUR WOODCHUCK. FAILURE TO HEED MAY RE- SULT IN SERIOUS PERSONAL INJURY OR DEATH.

OPERATION PROCEDURE IN THECAUTION:

￿RISK OF FIRE

￿DO NOT OPERATE WITH FUEL LOADING OR ASH REMOVAL DOORS OPEN.

￿DO NOT STORE FUEL OR OTHER COMBUSTI- BLE MATERIAL WITHIN MARKED INSTALLATION CLEARANCES.

￿INSPECT AND CLEAN FLUES AND CHIMNEY REGULARLY.

￿UNDER CERTAIN CONDITIONS OF USE, CREO- SOTE BUILDUP MAY OCCUR RAPIDLY.

￿WAIT 10 SEC. ON FIRST LATCH BEFORE RE- FUELING.

￿LOAD FUEL CAREFULLY OR DAMAGE MAY RE- SULT.

! IF YOU HAVE CHIMNEY FIRE !

Meyer Mfg. Corp. recommends the following actions:

1.Shut any doors and air inlet dampers and draft con- trol. This should take no longer than a few seconds.

CLOSED

2. Alert everyone in the house.

3. Call the fire department.

MANUAL DRAFT

NOTE: Emptying a large box of baking soda will slow down the fire in your Woodchuck.

Keeping your chimney and stove pipe clean is the best insurance against chimney fires.

! IMPORTANT !

OPERATION PROCEDURE IN THE

EVENT OF POWER FAILURE:

Your Woodchuck can operate and produce heat without electric power. This is one of the features built into ev- ery Woodchuck.

The following steps should be taken in the event of an electrical power failure:

1. Locate all heating duct dampers (not smoke pipe

damper), if any, to open position.

CLOSED

2. Turn manual draft controls to this position.

Ash door should never be used

MANUAL DRAFT

in power failure.

 

 

 

 

3.Remove filter box service access cover, allowing cooler air to move hot air through the furnace, cooling the plenum and the house hot air duct system.

If power fails, to avoid product damage, close manual draft completely. Forced draft and natural draft are pre- set.

In the event of a runaway fire, close all drafts. Close smoke damper halfway.

8

Image 9
Contents MODELS INSTRUCTION AND PARTS BOOK FORPhone 715/654-5132 Fax 715/654-5513 07/97Page TRANSPORTATION DAMAGES INTRODUCTIONTABLE OF CONTENTS DANGER FURNACE SAFETYDANGER DANGERMODEL SPECIFICATIONSDISCLAIMER NOTICE MODELHIGH QUALITY CONSTRUCTION GENERAL INFORMATIONEFFICIENCY COMFORTFIGURE FIGURE ADDITION COMFORT AND SAVINGOPERATION OPERATION PROCEDURE IN THE EVENT OF POWER FAILURECOMMON SENSE IF YOU HAVE CHIMNEY FIREBURNING WOOD IN YOUR WOOD- CHUCK OPERATING YOUR WOODCHUCK FURNACESTARTUP FIGURE 5 WOODCHUCK CONTROLSHELPFUL HINTS ASH REMOVALSTARTING A COAL FIRE BURNING COAL IN YOUR WOOD- CHUCKRECHARGING BANKINGMAINTENANCE OPTIONAL CATALYTIC COMBUSTOR FOR MODELS 2900/4000ASH REMOVAL PROBLEM TROUBLE SHOOTINGSOLUTION POSSIBLE CAUSESOLUTION PROBLEMPOSSIBLE CAUSE 9. Excessive amounts ofPLACEMENT AND MINIMUM CLEAR ANCES INSTALLATIONGENERAL REQUIREMENTS FIGURE 7 LOCATING THE WOODCHUCKFIGURE 8 TYPICAL CHIMNEY CHECKLIST CHIMNEY INSTALLATION TYPICAL STOVE PIPE INSTALLATIONFIGURE 9 CHIMNEY/ROOF CLEARANCE STOVE PIPE INSTALLATION INSTALLING YOUR WOODCHUCKINSTALLATION OF A BAROMETRIC DRAFT DAMPERS IN STOVE PIPESADD-ONINSTALLATIONS AIR DUCT INSTALLATIONOPTIONAL SHAKER GRATE INSTALLATION FOR MODEL WOODCHUCK FINAL ASSEMBLYFIGURE 12 PARALLEL ADD-ONINSTALLATION FIGURE 13 CENTRAL ADD-ONINSTALLATIONINSTALL SHAKER GRATE HANDLE MODEL 2900 ONLY FIGURE 14 POOR INSTALLATIONSFIGURE 15 INSTALL SHAKER GRATE HANDLE INSTALL FIREBRICK FIGURE 16 INSTALL OPTIONAL SHAKER GRATE FOR MODELFIGURE 17 INSTALL FIREBRICK ASSEMBLE MANUAL DRAFT MODEL 526 ONLY FIGURE 19 INSTALL MANUAL DRAFT-MODEL526INSTALL FILTER BOX INSTALL CIRCULATING BLOWERELECTRICAL HOOKUP FIGURE FIGURE 21 INSTALL CIRCULATING BLOWER AND FILTERFIGURE 22 ELECTRICAL WIRING DIAGRAM BASIC UNIT FOR MODEL REPAIR PARTSKEY NO. PART NO DESCRIPTIONKEY NO. PART NO BASIC UNIT FOR MODELDESCRIPTION KEY NO. PART NOKEY NO. PART NO BASIC UNIT FOR MODELDESCRIPTION KEY NO. PART NOSHAKER GRATE FOR MODELS 2900/4000 OPTIONAL SHAKER GRATE FOR MODELFILTER BOX 2900/4000CIRCULATING BLOWER COMFORT CONTROL DESCRIPTIONKEY NO. PART NO. DESCRIPTION PERSONAL DATA INFORMATION FOR FUTURE REFERENCE Page LIMITED WARRANTY
Related manuals
Manual 36 pages 11.61 Kb