368262-UIM-B-1008
ADJUSTMENT OF FAN CONTROL SETTINGS
Cooling - The airflow delivered by the furnace during cooling operation can be adjusted to match the cooling capacity of the A/C condensing unit. This is done by moving the COOL and ADJ jumper on the control board to give the desired airflow.
The COOL jumper has four positions, which will deliver sufficient airflow in cooling mode for the cooling capacities shown in Table 13.
the ADJ jumper has three positions which can be used to make further adjustments to the cooling blower airflow.
Continuous Fan Operation - The airflow delivered by the furnace dur- ing continuous fan operation can be adjusted as desired. This is done my moving the control fan jumper on the control board to give the desired airflow.
The jumper has three positions. The "H" position delivers maximum air- flow, 100% of the blower capacity. Position "M" delivers approximately 70% of the blower capacity. And Position "L" delivers minimum airflow, approximately 40% of the blower capacity.
Humidifier | EAC | |
Terminals | ||
Terminals | ||
|
Zoning
Jumper
Heat Pump
Jumper
Cooling
Speed
Jumper
Humidistat
Jumper
Continuous
Fan Speed
Jumper
Test
Button
Diagnostic | Low | Last | |
Voltage | Error | ||
Light | |||
Terminals | Button | ||
|
FIGURE 29: Furnace Control Board
26 | Johnson Controls Unitary Products |