Meyer 526, 4000 manual INSTALL SHAKER GRATE HANDLE MODEL 2900 ONLY, Poor Installations

4. Assemble the right front bar to a rear bar. Slide a gear onto the front shaft, aligning it to engage the gear on the left bar. Place the front bar onto the front frame and then setting the rear bar onto the rear frame.

5. Place rear retainer in place, then the center and the front retainers. Place all four bolts through retainers and frame. Secure with locknuts. To prevent binding, it is ad- visable to snug the locknuts but do not over tighten.

6. Try moving the shaker grate bars with the handle. NOTE: Both bars in normal position should be flat. If not, one or the other gear is not aligned correctly.

7. To install the assembly into the unit, place the front end of the assembled grate on the loading door lower frame. The grate should be the upside down position. Slide the grate (front end first) into the firebox allowing the front end to lower into the hearth area. Once the back end of the grate has cleared the door frame, “flip” it over toward the rear of the unit. If necessary, reach into the ash pit door and pull the front of the grate forward until it lodges into place.

INSTALL SHAKER GRATE HANDLE,

MODEL 2900 ONLY

1. Open the door ash door. Slide the shaker grate handle through the opening in the side of the door frame and guide it through the actuator arm and into the receiving boss on the opposite side of the frame.

2. Secure handle to actuator with 1/4x1-1/2 bolt and nut. See figure 15.

SHAKER GRATE HANDLE

ACTUATOR ARM

RECEIVING BOSS

	1/4x1-1/2 BOLT
	ALIGN HOLES	ASH DOOR FRAME
FIGURE 14 POOR INSTALLATIONS	FIGURE 15 INSTALL SHAKER GRATE HANDLE

21