Louisville Tin and Stove 78111 warranty Standing Pilot For Your Safety Read Before Lighting

Page 10

CF353C-H, CF354C-H, CF503C-H, CF504C-H, CF653C-H, CF654C-H

STANDING PILOT

FOR YOUR SAFETY READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result

causing property damage, personal injury or loss of life.

A.This appliance has a pilot, which must be lighted by hand. When lighting the pilot, follow these instruc- tions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS:

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service technician. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to

inspect the appliance and to replace any part of the control system and any gas control which has been

under water.

PN 91217 02/05

LIGHTING INSTRUCTIONS

1.STOP! Read the information on the safety label.

2.Set thermostat to lowest setting.

3.Turn off all electric power to the appliance.

4.Remove lower front panel.

5.Push in gas control knob slightly and and turn

clockwise to “OFF”.

Gas Control Knob

Pilot Control Knob

NOTE: Knob can not be turned from “PILOT” to “OFF” unless knob is pushed in slightly.

Do not force.

9.Push in pilot control knob and hold in. Immediately begin a series of pushing and releasing the red piezo ignitor button, while observing the pilot. Continue to spark until pilot is lit. Continue to hold the pilot control knob in for about one (1) minute after the pilot is lit. Release the pilot control knob and it will pop back up. Pilot should remain lit. If pilot goes out, repeat steps 5 thru 9.

• If knob does not pop up when released, STOP and

6.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the information on the safety label. If you don’t smell gas, go to the next step.

7.Locate red piezo ignitor button. Locate pilot. (Follow metal pilot tube from gas control).

8.Turn gas control knob counterclockwise to “PILOT”.

immediately call your service technician or gas supplier.

• If the pilot will not stay lit after several tries, turn the

gas control knob to “OFF” and call your service

technician or gas supplier.

10.Turn gas control knob counterclockwise to “ON”.

11.Replace lower front panel.

12.Turn on all electric to the appliance.

13.Set thermostat to desired setting.

PN 91217 02/05

TO TURN OFF GAS TO APPLIANCE

1.Turn thermostat to lowest setting.

2.Turn off all electric power to the appliance if service is to be performed.

3.Remove lower front panel.

Page 10

4.Push in gas control knob slightly and turn clockwise

to “OFF”. Do not force.

5.Replace lower front panel.

PN 91217 02/05

Page 9 Page 11
Image 10
Page 9 Page 11
Contents What to do Ifyou Smell GAS Installation and Service Must be PerformedByaqualified INSTALLER, Service Agency or GAS SupplierCounterflow Wall Furnace Specifications ContentsIntroduction Read Carefully Before Installing Unit Safety RulesVenting Venting See Listof Possiblecausesand Corrections on PAGE19Combustionandventilationair ROUGH-IN Instructions Location and Special PrecautionsElectrical ROUGH-IN GAS ROUGH-IN Installation When Installed Flush to Wall Installation / When RecessedNatural GAS Pilot AdjustmentPilot Flame Adjustment GASTo Turn OFF GAS to Appliance Standing Pilot For Your Safety Read Before LightingLighting Instructions What to do if YOU Smell GASWhatto do Ifyou Smellgas Gascontrol KnobProper Burner Flame OperationMaintenance Instructions Auxiliary Limit SwitchTerminal Block Wiring Diagram Schematic CF353C-H, CF354C-H Pictorial SchematicPictorial Schematic Standing Pilot CF503/504C-H, CF653/654C-HPictorial Model no AmpsRear Optional Accessory KitsROUGH-INS for Rear or Side Discharge SideModel Optional KitsSide Discharge on Casing NumberTrouble Shooting Chart for qualified serviceman Main Burner Trouble Shooting Chart Pilot and ValveSymptom Possible Causes Corrective Action Possible Causes Corrective ActionCounterflow Wall Furnace / Standing Pilot ReplacementpartsControl Assembly USE OnlyfactorysuppliedRequires TWO VO LT System W ITH LO W -B.T.U. Standing Pilo TNAT. GAS CF357C-H CF557C-H Counterflow Wall Furnace / I.I.D. PilotModels VO LT S YS TEM W ITH Intermittent IG Nitio N I.I.D KIT no Rear Register W Boot FlushKIT no 306SR-A Side Register Flush 30SRB-A Rear Register RecessREV /05 March Your GAS Control and Pilot Light System Tampering is DangerousLimited

78111 specifications

Louisville Tin and Stove 78111 has firmly established itself as a leading provider of heating and cooling solutions in the heart of Louisville, Texas. Known for its commitment to quality craftsmanship and customer satisfaction, this company offers a diverse range of products tailored to meet a variety of residential and commercial needs. One of the standout features of Louisville Tin and Stove is its extensive selection of traditional and contemporary stoves, which include wood, gas, and pellet options. These stoves are designed to provide efficient heating while adding a touch of style to any space.

The technology behind the products at Louisville Tin and Stove focuses on efficiency and sustainability. Many of the stoves are engineered with advanced combustion systems that maximize heat output while minimizing emissions. This not only promotes environmental responsibility but also enhances the cost-effectiveness of heating systems. High-efficiency models are equipped with features such as automated ignitions, programmable thermostats, and even smart technology that allows users to control their heating systems remotely from their smartphones.

In addition to stoves, Louisville Tin and Stove specializes in custom metal fabrication. Whether it’s for a personalized chimney cap or a unique fireplace surround, the skilled craftsmen at this company can bring any vision to life. Their attention to detail and use of high-quality materials ensure that each piece is not only functional but also visually appealing.

Another critical characteristic of Louisville Tin and Stove 78111 is its focus on customer support. The knowledgeable staff is always on hand to provide expert advice on product selection, installation, and maintenance. This commitment to exceptional service ensures that customers feel confident in their purchases and satisfied with their heating solutions.

Overall, Louisville Tin and Stove 78111 combines traditional craftsmanship with modern technology, resulting in a product line that is both stylish and efficient. Whether you’re looking to upgrade your home’s heating system or need a bespoke metal piece, Louisville Tin and Stove stands ready to meet your needs with professionalism and expertise.
Top Page Image Contents