CC880/LP880, SC8016 Operators Guide 26.0 | Domestic Voice Message |
Reporting |
|
| Zone Status |
EN 17
26.0 Domestic Voice Message Reporting
The system can be configured by your security company to report to your mobile phone when an alarm occurs and play back a
The
16 sec. in length) can be changed as many times as necessary. You need to discuss the recording of your message with your security company. To change or program new telephone numbers, see Section 25.2 Programming Domestic Telephone Numbers.
26.1Acknowledging Domestic Voice Message Reporting
When an alarm registers at the control panel, the control panel starts dialling the first telephone number. The recorded voice message starts playback as soon as the control panel dials the first telephone number and repeats itself continuously for 90 seconds.
When you answer the incoming call from the control panel, wait for the recorded message to end. A series of short tones follow the recorded message followed by a 20 sec. pause before the control panel hangs up and dials the next telephone number.
During the 20 sec. pause, press the [*] button on your
If an optional DTMF Command Module is installed by your security company, you can acknowledge the call during the message playback by pressing the [#] key. You no longer need to wait for the
27.0 Basic Pager Reporting
This feature is only applicable if your system is reporting to a pocket pager. Basic pager reporting requires some interpretation of the numbers that appear on the display. It is possible to differentiate between 1000 different systems when a number of control panels are reporting to the one pocket pager.
27.1Basic Pager Display Information
The zone status display shows you the status of each zone (1 to 8). Table 15 describes what each number means when displayed on the zone status display.
Table 15: Zone Status Display Descriptions
Number | Zone |
Displayed | Description |
0 | Zone Normal |
| Indicates the corresponding zone is in the |
| sealed state. |
1 | Alarm |
| Indicates the corresponding zone is unsealed |
| and in alarm condition. |
2 | Zone Bypassed |
| Indicates a system operator manually isolated |
| the corresponding zone. See Section 13.0 |
| Isolating Zones for information on how to |
| manually isolate a zone(s) prior to arming the |
| system. |
3 | Zone Trouble |
| Indicates a zone was left unsealed after the |
| end of exit time. |
System Status
The system status information is divided into four digits.
Table 16: System Status
System Status | Description | |
Display |
|
|
First digit | Indicates whether the system is armed | |
| or disarmed: | |
| 8 | = Disarmed |
| 9 | = Armed |
Second digit | Indicates which codepad alarm was | |
| triggered by the operator: | |
| 0 | = No Codepad Alarm |
| 1 | = Codepad Panic or Duress Alarm |
| 2 | = Codepad Fire Alarm |
| 3 | = Codepad Medical Alarm |
Third digit | Indicates when the AC mains supply has | |
| failed: | |
| 0 | = AC Supply is normal |
| 1 | = AC Supply has failed |
Fourth digit | Indicates when a system fault has | |
| occurred at the control panel: | |
| 0 | = System Normal – There are no |
| faults. | |
| 1 | = System Fault – There is a fault |
| registered by the control panel. | |
Subscriber ID Number
This is the identification number of the control panel and can only be programmed by your installer.
Bosch Security Systems 6/04 920036O.OG.162