båÅçêÉ=smñ=fåëí~ää~íáçå=dìáÇÉ
VPx Hardware
•In a 1 M/E system:
~M/E 1 connector priorities are relative to the connectors being used:
•The DVI Input A or Analog Input A connector could be set up as a Background input (lowest priority).
•The DVI Input B or Analog Input B connector could be setup as a DSK input (highest priority).
This leaves the other connectors to fall in between Background and DSK. The rule stating that “A” connectors are lower in priority than “B” connectors still holds.
~M/E 2 and 3 connectors are not installed.
jLb=fåéìí=kçíÉë
Please note the following important points regarding M/E inputs:
•Single Processor Configurations — In the special widescreen “preview” configuration, a VPx can be used as a standalone destination that accepts DVI input signals only.
•Multiple Processor Configurations — In these configurations, you only need to connect inputs to the first VP. Inputs are automatically looped to all other VP and VPx units via the Source Link connections.
•
~The “digital” side accepts connections from a standard DVI output or digital graphic router. This side can be used as both a scaled input source or as an unscaled Background / DSK source.
~Using a breakout cable, the “analog” side accepts analog connections. This side is designed for inputting the system’s unscaled sources — Background and DSK.
•The lowest priority M/E in your system must be used for inputting the Background source.
•The highest priority M/E in your system must be used for inputting the DSK source.
mêçÖê~ã=lìíéìí=kçíÉë
Please note the following important points regarding the Processor’s program outputs:
•
•
•
HD/SDI Outputs — For the HD/SDI output, you can set the output to be SDI (SMPTE
DVI Program Outputs — DVI Program outputs are digital only. They do not have analog connections.
Program 1 Outputs — Edge feathering and data doubling are present on all Program 1 Outputs, provided that those features are enabled in the system’s Output Menu.
14 |
| Encore VPx Installation Guide • |
|