båÅçêÉ=smñ=fåëí~ää~íáçå=dìáÇÉ
Installation
•
•
•
Distribute the units evenly to prevent hazardous conditions that may be created by uneven weight distribution.
Rack mount the units from the front rack ears using four rack screws (not supplied). Threads may be metric or otherwise — depending upon the rack type.
Install the lower of the two mounting holes first.
fåëí~ääáåÖ=smñ
This section provides detailed VPx installation procedures for the Encore configurations listed below. Select the desired configuration, and follow all steps.
Important
Only valid VPx configuration procedures are included below. Note that steps for connecting peripherals (e.g., ScreenPRO- II, Aux destinations, routers, tally, D/As, etc.) in a system are not covered below, but are fully covered in Chapter 3 of the Encore Presentation System User’s Guide.
Important
Software version 1.22 (or higher) must be installed first in your Encore Controller, prior to connecting your VPx processor(s). Refer to Appendix C, “Upgrading Software” in the Encore Presentation System User’s Guide for complete upgrade instructions.
The following installation procedures are provided:
•
•
•
Installing VPX in a Wide Screen Configuration Installing VPx in a Wide Screen Preview Configuration Installing VPx in a Wide Screen Stack Configuration
16 |
| Encore VPx Installation Guide • |
|