Barco 08-0311105-00 installation instructions Equipment List, Wide Screen Stack Configuration

båÅçêÉ=smñ=fåëí~ää~íáçå=dìáÇÉ

Installation

For this procedure, you will need:

Table 5.	Equipment List, Wide Screen Stack Configuration
Qty.	Item	Note
2	VP	Master units (ID#1 and ID#2) must be VP, not VPx.
2	VP or VPx	The ID of the bottom stack processor must always be lower than the ID
		of the top stack processor. Use 6 total processors for triple wide
		screen, use 8 for quadruple wide, etc.
1	Controller	Model LC only
2	Video Projectors	Customer supplied
4	DVI or Analog Monitors	Program and Preview (customer supplied)
1	Ethernet Switch	Customer supplied
5	Ethernet cables	Customer supplied. Additional cables required for routers.
TBD	Program Link Cables	Use 2 for double wide screen application, left justification
		Use 4 for triple wide screen application, left justification
		Use 4 for double wide screen application, center justification
		Use 6 for triple wide screen application, center justification
TDB	Source Link Cables	Minimum 4 for double wide screen application.
TBD	Sources, routers, cables	Analog, Video and/or DVI as required (customer supplied)

„Use the following steps to install a wide screen “stack” configuration:

Important

It is recommended that each stack consists of two “fully loaded” processors, each with three M/Es. If necessary, you can use a mis-matched configuration (e.g., two M/Es in the bottom stack, three in the top), but the top stack must always have three M/Es installed. In this way, your stacked set will never have anything less than four M/Es available.

1.Software Version — Prior to connecting your VPx processor(s), ensure that software version 1.22 (or higher) is installed in your Encore Controller. Refer to Appendix C, “Upgrading Software” in the Encore Presentation System User’s Guide for complete upgrade instructions.

2.Follow the unpacking procedures as listed in the “Unpacking and Inspection” section on page 15.

3.Refer to the “Technical Specifications” section on page 28 for electrical and mechanical details.

4.Refer to the “VPx Hardware” section on page 8 for all connector locations.

5.For each VPx, follow the rack mount procedures as outlined in the “Rack-Mount Installation” section on page 15.

Important

Remember that master units (ID#1 and ID#2) must be VP, not VPx. “Slave” units can be VP or VPx.

24 Encore VPx Installation Guide • 08-0311105-00 Rev 00