båÅçêÉ=smñ=fåëí~ää~íáçå=dìáÇÉ
Installation
8.Stack Interconnections —
a.On the first stack:
•Connect the bottom stack’s DVI Preview Output to the top stack’s Background 1 input (3A).
•Connect the bottom stack’s DVI Program Output to the top stack’s Background 2 input (3B).
b.On the second stack:
•Connect the bottom stack’s DVI Preview Output to the top stack’s Background 1 input (3A).
•Connect the bottom stack’s DVI Program Output to the top stack’s Background 2 input (3B).
9.Output Connections — all output monitor and projector connections originate from the “top stack” processors:
a.On each “top stack” processor, connect the analog or digital Preview Output to the input of the associated Preview Monitor.
b.On each “top stack” processor, connect the analog or digital Program 2 Output to the input of the associated Program Monitor.
c.On each “top stack” processor, connect the analog or digital Program 1 Output to the input of the associated projector.
d.Connect the “top stack” Program Out HD/SDI connector to an SDI or HDTV monitor, or to the proper video distribution equipment.
Note
This output only works if the selected output resolution is a valid SDI or HD/SDI format.
e.If you elect to output in an interlaced format (e.g., 1920 x 1080i), connect each top stack’s H Sync Output signal (located on the Program 2 Out Analog connector) to the Genlock input on the bottom stack.
Note
Using a (customer supplied) VGA to 5xBNC breakout cable, the H Sync Output line is typically a white or gray cable.
10.Link Connections — in a widescreen application, the Program Link and Source Link connections are used to connect processors together, and bridge inputs and outputs for the proper “overlap” between projectors. In Chapter 3 of the Encore Presentation System User’s Guide, refer to the “Program and Source Link Connections” section for details.
11.Power Connection — connect AC power cords to all Encore and peripheral equipment, and then to AC outlets.
12.System ID — Using the Unit ID Selector:
a.On the first stack, set the ID of the bottom stack Processor to 1 (VP only) Set the ID of the top stack Processor to 2 (VP or VPx).
26 |
| Encore VPx Installation Guide • |
|