TP-Link TL-SC2020N Mount the Camera, Hardware Connection, The Screw Size, Wall and Ceiling Mount

2.4 Mount the Camera

2.4.1 The Screw Size

There are three supplied screws for mounting the Camera. The length of the screws is 25±1 mm and the diameter is 4±0.2 mm.

2.4.2 Wall and Ceiling Mount

There are two ways to mount the Camera. See the following two pictures.

Ceiling Mount

Wall Mount

To mount the Camera, please follow the steps below:

1.Use the three supplied screws to fix the base plate to a flat surface.

2.Loosen the lock ring to adjust the desired angle of the Camera.

3.Tighten the lock ring.

2.5 Hardware Connection

Before proceeding, confirm that your PC is connected to your router and can access the Internet. Make sure that your router’s DHCP feature is enabled. If not, please refer to your router’s instruction to enable it.

For TL-SC2020N, you can set up either a Wired Connection or a Wireless Connection. To set up a wireless connection, if your Router supports WPS (Wi-Fi Protected Setup), please follow 2.5.2 Wireless Connection (by WPS) to finish connection; if your Router doesn’t support WPS, please refer to the

6