Programming Through Remote Link

Operator’s Guide

Programming of the SCS-150 can be performed using Remote Link version 1.47 or higher. Connect the computer with Remote Link installed to the 25-pin connector Auxiliary Port on the back of the SCS-1R Receiver using an SCS-204 cable. Note: Each SCS-150 programming section in Remote Link is independent and changes should be sent to the receiver after programming is completed for each window.

Programming Menu

Allows entry to the programming menu for the SCS-1R using the keypad display.

MENU? NO YES

ENTER CODE: 6653

Menu?

Select YES to enter the programming code. Select NO to return to the Time Display.

Programming Code

Enter PROG (6653) to enter the Programming Menu.

Service Code (XR500 Series panels)

This option allows the entry of a 5-digit service authorization code used to authenticate service personnel before allowing access to panel programming or performing any user operations.

SCS-1R Menu

SERVICE CODE

SERVICE CODE 00000

Receiver Options

Service Code (XR500 Series panels)

Press any top row Select key to enter the Service Code. Press the COMMAND key to advance to the next section of programming.

Range for the 5‑digit code is 00000-65535. When this feature is enabled on an XR500 Series panel a service person is required to enter a valid service user code for system programming access. Once the code is authenticated with the receiver, access to panel programming is granted. If the code is not authenticated, access is denied.

The receiver cannot authenticate service personnel until a number is entered at this option. Entering 00000 at the receiver disables this operation and panel access is always granted.

Note: This panel operation is available to purchase for XR500 Series panels with version 108 or higher software. Refer to the Feature Upgrade section in the XR500 Series Programming Guide (LT-0679) for additional information.

This section assigns the company name and system number as well as the communication type for each SCS-1R Receiver incoming line.

SCS-1R Menu

RECEIVER OPTIONS

Company Name

Company Name 2

RECEIVER System Number: 1

Receiver Key

Key:********

Receiver Options

Press any top row Select key to display the company name and configure the system. Press the COMMAND key to advance to the next section of programming.

Company Name

Enter your company name using two lines, each line can have up to 16 characters. Enter the first 16 characters and press the COMMAND key to accept.

Enter the second 16 characters and press the COMMAND key to accept.

Receiver System Number

The LCD displays the current receiver system number. Press any top row Select key, then enter the system number, 0 through 9. The default System Number is 1. Press the COMMAND key when finished.

Note: This identifier is used by the automation computer to distinguish between multiple SCS-1R systems.

Receiver Key

The current Receiver Key displays. Press the COMMAND key to leave the Receiver key the same and move to the next programming option. Press any top row Select key to change the Receiver Key.

Note: This is an eight-character alphanumeric entry. This key is requested by Command Processor™ panels in the field when using remote programming from this receiver. Once entered this key does not display and should never be changed. Record this number in the Important information Sheet at the end of this document and store in a secure place.

Enter the new Receiver Key up to eight characters long. Press the COMMAND key to display the next prompt.

Digital Monitoring Products

SCS-1R Installation Guide