Kenmore 334, 530 owner manual Sediment Traps, LINIONLACKPiPE

Page 17

Breathing Hazard - Carbon Monoxide Gas

•High altitude orifice must be installed for operation above 7,700 feet (2,347 m].

•Contact a qualified installer or service agency.

Breathing carbon monoxide can cause brain damage or death. Always read and understand instruction manual.

Water heaters covered in this manual have been tested and approved for installation at elevations up to 7,700 feet (2,347 m) above sea level. For installation above 7,700 feet (2,347 m), the water heater's Btu input should be reduced at the rate of 4 percent for each 1,0g0 feet (305 m) above sea level which

requires replacement of the burner orifice in accordance with

the National Fuel Gas CodeANSI Z223.1/NFPA54. Contact your local gas supplier for further information.

Failure to replace the standard orifice with the proper high

altitude orifice when installed at elevations above 7,700 feet (2,347m) could result in improper and inefficient operation of

the appliance, producing carbon monoxide gas in excess of the safe limits. This could result in serious injury or death. Contact your local gas supplier for any specific changes that may be required in your area.

Fire and Explosion Hazard

o Use joint compound or tape compatible with propane.

= Leak test before operating heater.

-Disconnectgas piping and shut-off valve before pressure testing system.

Use pipe joint compound or teflon tape marked as being resistant to the action of petroleum (Propane [L.R]) gases.

The appliance and its gas connection must be leak tested before placing the appliance in operation.

The appliance and its individual shutoff valve shall be

disconnected from the gas supply piping system during any

pressure testing of that system at test pressures in excess of

1/2 pound per square inch (3.5kPa). It shall be isolated from the gas supply piping system by closing its individual manual shutoff valve during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 pound per square inch (3.5kPa).

Connecting the gas piping to the gas control valve of the water

heater can be accomplished by either of the two methods shown in Figures 19 and 20.

Sediment Traps

Fire and Explosion Hazard

•Contaminants in gas lines can causefire or explosion.

•Clean all gas piping before installation.

•Install drip leg in accordance with NFPA 54.

Contaminants in the gas lines may cause improper operation of

the gas control valve that may result in fire or explosion. Before attaching the gas line be sure that all gas pipe is clean on the inside. To trap any dirt or foreign material in the gas supply line,

a drip leg (sometimes called a sediment trap) must be

incorporated in the piping. The drip leg must be readily

accessible, install in accordance with the Gas Piping section. Refer to the current edition of the National Fuel Gas Code,

ANSi Z223.1iNFPA 54.

A sediment trap shall be installed as close to the inlet of the water heater as practical at the time of water heater installation. The sediment trap shall be either a tee fitting with a capped nipple in the bottom outlet or other device recognized as an effective sediment trap. If a tee fitting is used, it shall be installed

in conformance with one of the methods of installation, shown in Figures 19 and 20.

GROUND JOINT -

GAS CONTROL

(OPTIONALI

3" MIN_"

UNION

(78.2 ram} ,_

CAP

FIGURE 19. GAS PIPING WITH FLEXIBLE CONNECTOR.

GROUND JOIN1 _'_B

LINIONLACKPiPE

(OPT,ONAL} d,/

_. n GAS

cOX;v.OL

CAP

FIGURE 20. GAS PiPiNG WITH ALL

BLACK IRON PmPE TO GAS CONTROL,

17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Safety instructions , installation For Your SafetyOperation Care and Maintenance Troubleshooting Parts List Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.AImportant Definitions Fire or Explosion Hazard Improper installation and use may result Property damageFire Hazard Breathing Hazard Carbon Monoxide Gas11-12 CombustionAirandVentilationAppliances12-13 13-14Contractors ThankYouforpurchasingKenmorewaterheaterProperlyMaterials Needed Additional Tools Needed When Sweat SolderingSqueeze Tube USE for Water and GASPilot Thermopile Tubing TCO Closed Water SystemPilot Burner Removing the Old Water Heater Facts to Consider About Location Insulation Blankets MINFire or Explosion Hazard Breathing Hazard Carbon Monoxide GasAllair from Inside Buildings Rgure Water PipingToxic Chemical Hazard LookatthetopofthewaterheaterThecoldwaterinletis NotbeintroducedintothissystemProperty Damage Hazard PiPE INSULATiON Flue PiPEWater Damage Hazard Temperatu re=Pressu re Relief Valve×plosion Hazard Yo outdoors VentingProperty Damage Hazard Gas Piping RET,,,,LFire and Explosion Hazard Drafthood ChimneyLINIONLACKPiPE Sediment TrapsScald injury. Consult Instruction Rnanual before Changing TemperatureIf you cannot reach your gas suppltar,call the fire Generator Temperature RegulationThermostat Vent System Inspection Tank Sediment CleaningTEMPERATURE-PRESSURE Temperature=Pressure Relief Valve OperationHousekeeping DrainingOPENanearbyhotwaterfaucetandleaveopentoallowfor draining Drain Valve Washer ReplacementCLOSEthecoldwaterinletvalvetothewaterheater Expansion Tank Sizing Thermal Expansion TankStrange Sounds Draft Hood OperationOperational Conditions MakenecessaryairsupplychangestocorrectOperational Conditions Leakage Checkpoints Fortheseinstructions, please see Figure Screw GAS Valve BackplateLocking TAB Tank Thermopile Sensor Torx Gas control valve or tank sensor failure Tllllil LIST, not a Packing List 153.334530150Ga,on lPage MY-HOME 12YEARLIMITED Warranty on Water Heater

334, 530 specifications

The Kenmore 334,530 is a well-regarded appliance in the realm of portable air conditioning units, offering users an efficient cooling solution for both homes and office spaces. Known for its reliability and performance, this model blends advanced technology with user-friendly features to create a cooling experience that meets diverse needs.

One of the standout characteristics of the Kenmore 334,530 is its cooling capacity, rated at 14,000 BTU. This makes it suitable for medium to large-sized rooms, effectively cooling spaces up to 600 square feet. Users can expect rapid temperature drops, making it ideal for sweltering summer days when immediate relief is needed.

The unit features a sleek design that allows for easy portability. Equipped with rolling casters, the Kenmore 334,530 can be effortlessly moved from room to room, providing flexibility based on where cooling is needed most. The convenient window installation kit simplifies the setup process, allowing for a straightforward installation without the need for professional assistance.

Energy efficiency is another key highlight of the Kenmore 334,530. With an impressive Energy Efficiency Ratio (EER), this air conditioner is designed to minimize electricity consumption while maintaining powerful cooling performance. Users can stay cool without worrying excessively about their energy bills.

Additionally, the Kenmore 334,530 is equipped with a programmable thermostat and remote control, allowing users to customize their cooling experience. The programmable timer can be set to operate at specific times, ensuring the room is cool when needed while saving energy when it isn't. The user-friendly interface and digital display make adjustments quick and intuitive.

The unit also features multiple fan speeds and cooling modes, including a dehumidifying option that removes excess moisture from the air. This capability not only enhances comfort but contributes to a healthier indoor environment by preventing mold and mildew growth.

In terms of maintenance, the Kenmore 334,530 includes an easy-to-clean washable filter that captures dust and allergens, promoting cleaner air circulation. This filter is designed to be simple to access and maintain, ensuring ongoing efficiency and performance.

Overall, the Kenmore 334,530 stands out in the portable air conditioning market, offering a combination of power, efficiency, and convenience. Its thoughtful features and advanced technology make it an excellent choice for anyone seeking reliable cooling solutions in various settings.
Top Page Image Contents