Kenmore 334, 530 owner manual Facts to Consider About Location, Fire or Explosion Hazard

Page 9

Facts to Consider About

the Location

Carefully choose an indoor location for the new water heater,

because the placement is a very important consideration for the

safety of the occupants in the building and for the most

economical use of the appliance. This water heater is not for

use in manufactured (mobile) homes or outdoor installation.

Whether replacing an old water heater or putting the water heater in a new location, the following critical points must be observed:

Select a location indoors as close as practical to the gas vent or chimney to which the water heater vent is going to be connected, and as centralized with the water piping system as possible.

• Selected location must provide adequate clearances for servicing and proper operation of the water heater.

Property Damage Hazard

, All water heaters eventually leak

Do not install without adequate drainage.

Installation of the water heater must be accomplished in such a

manner that if the tank or any connections should leak, the flow

will not cause damage to the structure. For this reason, it is not advisable to install the water heater in an attic or upper floor. When such locations cannot be avoided, a suitable drain pan

should be installed under the water heater. Drain pans are available at your local Sears or hardware store. Such a drain pan must have a minimum length and width of at least 2 inches (51 mm) greater that the water heater dimensions and must be piped to an adequate drain. The pan must not restrict combustion air flow.

Water heater life depends upon water quality, water pressure

and the environment in which the water heater is installed. Water heaters are sometimes installed in locations where leakage may result in property damage, even with the use of a drain pan piped

to a drain. However, unanticipated damage can be reduced or prevented by a leak detector or water shut-off device used in conjunction with a piped drain pan. These devices are available from some plumbing supply wholesalers and retailers, and detect and react to leakage in various ways:

Sensors mounted in the drain pan that trigger an alarm or

turn off the incoming water to the water heater when leakage is detected.

Sensors mounted in the drain pan that turn off the water supply to the entire home when water is detected in the drain pan.

Water supply shut-off devices that activate based on the water pressure differential between the cold water and hot water pipes connected to the water heater.

Devices that will turn off the gas supply to a gas water heater while at the same time shutting off its water supply.

Fire or Explosion Hazard

*Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

,Avoid all ignition sources if you smell LP gas.

,Do not expose water heater control to excessive gas

pressure.

-Use only gas shown on rating plate.

-Maintain required clearances to combustibles.

. Keep ignition sources away from faucets after _, extended period of non-use.

Read instruction manual before

installing, using or servicing water heater.

INSTALLATIONS IN AREAS WHERE FLAMMABLE LIQUIDS

(VAPORS) ARE LIKELY TO BE PRESENT OR STORED

(GARAGES, STORAGE AND UTILITY AREAS, ETC.):

Flammable liquids (such as gasoline, solvents, propane [LP or butane, etc.] and other substances such as adhesives, etc.) emit flammable vapors which can be ignited by a gas water heater's pilot light or main burner. The resulting flashback and fire can cause death or serious burns to anyone in the area. Even though this water heater is a flammable vapors ignition resistant water heater and is designed to reduce the chances of flammable vapors being ignited, gasoline and other flammable substances should never be stored or used in the same vicinity or area

containing a gas water heater or other open flame or spark producing appliance.

Also, the water heater must be located and/or protected so it is not subject to physical damage by a moving vehicle.

Fire Hazard

For continued protection against risk of fire:

Do not install water heater on carpeted floor.

. Do not operate water heater if flood damaged.

This water heater must not be installed directly on carpeting. Carpeting must be protected by metal or wood panel beneath the appliance extending beyond the full width and depth of the appliance by at least 3 inches (76.2mm) in any direction, or if the appliance is installed in an alcove or closet, the entire floor must be covered by the panel. Failure to heed this warning may result in a fire hazard.

Image 9
Contents Safety instructions , installation For Your SafetyOperation Care and Maintenance Troubleshooting Parts List Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.AImportant Definitions Fire or Explosion Hazard Improper installation and use may result Property damageFire Hazard Breathing Hazard Carbon Monoxide Gas11-12 CombustionAirandVentilationAppliances12-13 13-14Contractors ThankYouforpurchasingKenmorewaterheaterProperlyMaterials Needed Additional Tools Needed When Sweat SolderingSqueeze Tube USE for Water and GASClosed Water System Pilot BurnerPilot Thermopile Tubing TCO Removing the Old Water Heater Facts to Consider About Location Insulation Blankets MINFire or Explosion Hazard Breathing Hazard Carbon Monoxide GasAllair from Inside Buildings Water Piping Toxic Chemical HazardRgure LookatthetopofthewaterheaterThecoldwaterinletis NotbeintroducedintothissystemProperty Damage Hazard PiPE INSULATiON Flue PiPETemperatu re=Pressu re Relief Valve ×plosion HazardWater Damage Hazard Venting Property Damage HazardYo outdoors Gas Piping RET,,,,LFire and Explosion Hazard Drafthood ChimneyLINIONLACKPiPE Sediment TrapsRnanual before Changing Temperature If you cannot reach your gas suppltar,call the fireScald injury. Consult Instruction Temperature Regulation ThermostatGenerator Vent System Inspection Tank Sediment CleaningTEMPERATURE-PRESSURE Temperature=Pressure Relief Valve OperationHousekeeping DrainingDrain Valve Washer Replacement CLOSEthecoldwaterinletvalvetothewaterheaterOPENanearbyhotwaterfaucetandleaveopentoallowfor draining Expansion Tank Sizing Thermal Expansion TankStrange Sounds Draft Hood OperationOperational Conditions MakenecessaryairsupplychangestocorrectOperational Conditions Leakage Checkpoints Fortheseinstructions, please see Figure GAS Valve Backplate Locking TAB Tank Thermopile Sensor TorxScrew Gas control valve or tank sensor failure Tllllil LIST, not a Packing List 153.334530150Ga,on lPage MY-HOME 12YEARLIMITED Warranty on Water Heater

334, 530 specifications

The Kenmore 334,530 is a well-regarded appliance in the realm of portable air conditioning units, offering users an efficient cooling solution for both homes and office spaces. Known for its reliability and performance, this model blends advanced technology with user-friendly features to create a cooling experience that meets diverse needs.

One of the standout characteristics of the Kenmore 334,530 is its cooling capacity, rated at 14,000 BTU. This makes it suitable for medium to large-sized rooms, effectively cooling spaces up to 600 square feet. Users can expect rapid temperature drops, making it ideal for sweltering summer days when immediate relief is needed.

The unit features a sleek design that allows for easy portability. Equipped with rolling casters, the Kenmore 334,530 can be effortlessly moved from room to room, providing flexibility based on where cooling is needed most. The convenient window installation kit simplifies the setup process, allowing for a straightforward installation without the need for professional assistance.

Energy efficiency is another key highlight of the Kenmore 334,530. With an impressive Energy Efficiency Ratio (EER), this air conditioner is designed to minimize electricity consumption while maintaining powerful cooling performance. Users can stay cool without worrying excessively about their energy bills.

Additionally, the Kenmore 334,530 is equipped with a programmable thermostat and remote control, allowing users to customize their cooling experience. The programmable timer can be set to operate at specific times, ensuring the room is cool when needed while saving energy when it isn't. The user-friendly interface and digital display make adjustments quick and intuitive.

The unit also features multiple fan speeds and cooling modes, including a dehumidifying option that removes excess moisture from the air. This capability not only enhances comfort but contributes to a healthier indoor environment by preventing mold and mildew growth.

In terms of maintenance, the Kenmore 334,530 includes an easy-to-clean washable filter that captures dust and allergens, promoting cleaner air circulation. This filter is designed to be simple to access and maintain, ensuring ongoing efficiency and performance.

Overall, the Kenmore 334,530 stands out in the portable air conditioning market, offering a combination of power, efficiency, and convenience. Its thoughtful features and advanced technology make it an excellent choice for anyone seeking reliable cooling solutions in various settings.