Kenmore 334, 530 owner manual Tllllil

Page 29

TheseguidelinesshouldbeusedbyaqualifiedserviceagentCallSearsServiceat1.-800-4-MY-HOME(1-800-469-4663)

forassistanceInformtheassociatethatthisisa"FlammableVaporIgnitionResistant"Product..

/'i'i'tll

WATERLEAKS

LEAKINGT&PVALVE

SMELLYODORS

PILOTWILLNOTLIGHT

BURNERWILLNOTSTAYLIT

PILOTOUTAGE

NOTENOUGHHOTWATER

WATERTOOHOT

WATERHEATERSOUNDS

SIZZLING- RUMBLING

SOOTING

VENTGASODORS

-1_1,1-1

improperly sealed, hot or cold supply connection, relief valve, drain valve, or thermostat threads.

Leakage from other appliances or water lines.

Condensation of flue products.

Thermal expansion in closed water system.

Improperly seated valve.

High sulfate or mineral content in water supply.

Bacteria in water supply.

Gas knob dial not positioned correctly. Main gas supply off.

Igniter tip more than 1/8" from pilot hood. Thermopile malfunction.

Thermopile TCO malfunction.

Melted insulation on ignitor wire or shorting of ignitor wire.

High ambient room temperature.

Wire disconnected from piezo igniter. Broken electrode or electrical wire.

Piezo Igniter generator fails to operate or malfunctions.

Thermopile TCO malfunction.

High ambient room temperature.

Dirty or clogged intake Screen.

Flame arrestor openings blocked.

Defective Gas Control.

Dirty pilot burner.

Dirty or clogged Air Intake Screen. Thermopile malfunction.

Thermopile TCO malfunction. Defective Gas Control.

Heater not lit or thermostat not on. Thermostat set too low.

Heater undersized.

Low gas pressure.

incoming water is unusually cold. Leaking hot water pipes or fixtures.

High temperature limit switch activated.

Thermostat set too high. Condensation dripping on burner.

Sediment or calcium in bottom or heater tank.

improper combustion.

Lack of supply air.

improperly installed vent piping. Downdraft.

Poor Combustion.

-'tl'lll'il

Tighten threaded connections.

Inspect other appliances near water heater.

Refer to CONDENSATION.

Install thermal expansion tank (DO NOT plug T&P valve).

Check relief valve for proper operation

(DO NOT plug T&P valve).

Drain and flush heater thoroughly, then refill.

Chlorinate or aerate water supply. Refer to LIGHTING INSTRUCTIONS. Turn on main gas shutoff valve.

Adjust ignitor tip.

Replace pilot assembly.

Replace pilot assembly.

Contact Sears Service to determine cause.

Contact Sears Service to determine cause.

Reconnect wire connector to piezo igniter. Replace pilot assembly.

Replace electronic control module.

Replace pilot assembly.

Contact Sears Service to determine cause.

Clean and reinstall Air Intake Screen. Contact Sears Service to determine cause.

Replace Gas Control. Clean pilot assembly.

Clean and reinstall Air Intake Screen. Replace pilot assembly.

Replace pilot assembly. Replace Gas Control.

Refer to LIGHTING INSTRUCTIONS.

Refer to TEMPERATURE REGULATION. Reduce hot water use.

Contact your gas supplier.

Allow more time for your heater to re-heat.

Have plumber check and repair leaks. Contact Sears Service to determine cause.

Refer to TEMPERATURE REGULATION. Refer to CONDENSATION.

Clean sediment from tank. Refer to DRAINING instructions in Maintenance section of manual.

No adjustment available. Contact Sears Service to determine cause.

Contact Sears Service to determine cause.

29

Page 28 Page 30
Image 29
Page 28 Page 30
Contents Safety instructions , installation For Your SafetyOperation Care and Maintenance Troubleshooting Parts List Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.AImportant Definitions Fire or Explosion Hazard Improper installation and use may result Property damageFire Hazard Breathing Hazard Carbon Monoxide Gas11-12 CombustionAirandVentilationAppliances12-13 13-14Contractors ThankYouforpurchasingKenmorewaterheaterProperlyMaterials Needed Additional Tools Needed When Sweat SolderingSqueeze Tube USE for Water and GASPilot Thermopile Tubing TCO Closed Water SystemPilot Burner Removing the Old Water Heater Facts to Consider About Location Insulation Blankets MINFire or Explosion Hazard Breathing Hazard Carbon Monoxide GasAllair from Inside Buildings Rgure Water PipingToxic Chemical Hazard LookatthetopofthewaterheaterThecoldwaterinletis NotbeintroducedintothissystemProperty Damage Hazard PiPE INSULATiON Flue PiPEWater Damage Hazard Temperatu re=Pressu re Relief Valve×plosion Hazard Yo outdoors VentingProperty Damage Hazard Gas Piping RET,,,,LFire and Explosion Hazard Drafthood ChimneyLINIONLACKPiPE Sediment TrapsScald injury. Consult Instruction Rnanual before Changing TemperatureIf you cannot reach your gas suppltar,call the fire Generator Temperature RegulationThermostat Vent System Inspection Tank Sediment CleaningTEMPERATURE-PRESSURE Temperature=Pressure Relief Valve OperationHousekeeping DrainingOPENanearbyhotwaterfaucetandleaveopentoallowfor draining Drain Valve Washer ReplacementCLOSEthecoldwaterinletvalvetothewaterheater Expansion Tank Sizing Thermal Expansion TankStrange Sounds Draft Hood OperationOperational Conditions MakenecessaryairsupplychangestocorrectOperational Conditions Leakage Checkpoints Fortheseinstructions, please see Figure Screw GAS Valve BackplateLocking TAB Tank Thermopile Sensor Torx Gas control valve or tank sensor failure Tllllil LIST, not a Packing List 153.334530150Ga,on lPage MY-HOME 12YEARLIMITED Warranty on Water Heater

334, 530 specifications

The Kenmore 334,530 is a well-regarded appliance in the realm of portable air conditioning units, offering users an efficient cooling solution for both homes and office spaces. Known for its reliability and performance, this model blends advanced technology with user-friendly features to create a cooling experience that meets diverse needs.

One of the standout characteristics of the Kenmore 334,530 is its cooling capacity, rated at 14,000 BTU. This makes it suitable for medium to large-sized rooms, effectively cooling spaces up to 600 square feet. Users can expect rapid temperature drops, making it ideal for sweltering summer days when immediate relief is needed.

The unit features a sleek design that allows for easy portability. Equipped with rolling casters, the Kenmore 334,530 can be effortlessly moved from room to room, providing flexibility based on where cooling is needed most. The convenient window installation kit simplifies the setup process, allowing for a straightforward installation without the need for professional assistance.

Energy efficiency is another key highlight of the Kenmore 334,530. With an impressive Energy Efficiency Ratio (EER), this air conditioner is designed to minimize electricity consumption while maintaining powerful cooling performance. Users can stay cool without worrying excessively about their energy bills.

Additionally, the Kenmore 334,530 is equipped with a programmable thermostat and remote control, allowing users to customize their cooling experience. The programmable timer can be set to operate at specific times, ensuring the room is cool when needed while saving energy when it isn't. The user-friendly interface and digital display make adjustments quick and intuitive.

The unit also features multiple fan speeds and cooling modes, including a dehumidifying option that removes excess moisture from the air. This capability not only enhances comfort but contributes to a healthier indoor environment by preventing mold and mildew growth.

In terms of maintenance, the Kenmore 334,530 includes an easy-to-clean washable filter that captures dust and allergens, promoting cleaner air circulation. This filter is designed to be simple to access and maintain, ensuring ongoing efficiency and performance.

Overall, the Kenmore 334,530 stands out in the portable air conditioning market, offering a combination of power, efficiency, and convenience. Its thoughtful features and advanced technology make it an excellent choice for anyone seeking reliable cooling solutions in various settings.
Top Page Image Contents