Kenmore 153.33449, 153.33459, 153.33439 Service and Adjustment contd, Temperature-Pressure Relief

Page 21

Service and Adjustment (cont'd)

Draining

The water heater should be drained if being shut down during freezing temperatures. Also periodic draining and cleaning of sediment from the tank may be necessary.

Turn the gas control knob to the "OFF" position. CLOSE the cold water inlet valve to the water heater.

•OPEN a nearby hot water faucet and leave open to allow for draining.

•Connect a hose to the drain valve and terminate to an adequate drain.

•OPEN the water heater drain valve to allow for tank draining.

NOTE: If the water heater is going to be shut down and drained for an extended period, the draih valve should be left open with hose connected allowing water to terminate to an adequate drain.

•Close thedrain valve.

Follow instructions in the "Filling The Water Heater" section.

Follow the lighting instructions in the "Lighting" section to restart the water heater.

Temperature-Pressure Relief

Valve Operation

The temperature-pressure relief valve must be manually operated at least once a year.

TEMPERATURE-PRESSURE

VALVE

DISCHARGE PIPE

Failure to install and maintain a new properly listed tempera-

ture-pressure relief valve will release the manufacturer from any claim which might result from excessive temperature or pressure.

Drain Valve Washer

Replacement

NOTE: For replacement, use a *_" x *Yd' x %"thick washer

available at your fiearest hardware store. For ordering replace- merit washers, refer to the "Parts Order List" section.

Turn "OFF" gas supply to water heater. Follow "Draining" instructions.

Turning counter clockwise, remove the hex cap below the screw handle.

Remove the washer and put the new one in place.

Screw the handle and cap assembly back into the drain valve and retighten using a wrench. DO NOT OVER TIGHTEN.

Follow instructions in the "Filling The Water Heater" section.

Check for leaks_

Follow the lighting instructions in the "Lighting" section to restart the water heater.

._AP ASSEMBLY

Housekeeping

Vacuum around base of water heater for dust, dirt, and lint on a regular basis.

AWARNING

INSTALLED IN SUITABLE AREA: To insuresufficientventi- lation and combustionair supply,properclearancesfrom the water heater must be maintained. See "Facts to Consider About the Location"section.Combustiblematerialssuchas

clothing,cleaningmaterials,or flammable liquids,etc. must not be placedagainstor adjacentto the water heater which cancausea fire.

AWARNING

If the temperature-pressure relief valve on the appliance weepsor dischargesperiodically, this may be due to thermal expansion. Your water heater may have a check valve installed in the water line or a water meter with a check valve.Consultthe SearsService Center for further informa-

tion. Do not plugthe temperature-pressurereliefvaive.

AWARNING

When checkingthe tempernture-pressurereliefvalveopera- tion, make sure that (I) no one is in front of or aroundthe outlet of the temperature-pressurereliefvalvedischargeline, and (2) that the water manuallydischargedwill not causeany

property damage because the water may be extremely hot.

If after manually operating the valve, it fails to completely reset and continuesto release water, immediately closethe cold water inlet to the water heater, follow the draining

instructions, and replace the temperature-pressure relief valve with a new one.

Service

Before calling for repair service, read the "Start Up Conditions"

and "Operational Conditions" found in the Troubleshooting Guide of this manual.

If a condition persists or you are uncertain about the operation of the water heater, let a qualified person check it out.

Contact SEARS Repair Services at 1-800-4-MY-HOME

(1-800-469-4663).

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents What to do if YOU Smell GAS For Your SafetyModel No Odorant is Added to the GAS Used by this Inat E R HeaterSafety Precautions Water Heaters Equipped for ONE Type GASDEATH, Serious Bodily INJURY, or Property Safety Precautions Safety Precautions Contents Product SpecificationsCustomer RespOnsibilities @ 90F RiseMaterials and Basic Tools Needed Materials NeededBasic Tools Installation Instructions Removing the Old Water HeaterCut with a hacksaw approximately Installation Instructions contd Facts to Consider About LocationDEATH,SERIOUSBODILYINJUR,OR Propertydamage ALL AIR from Inside Buildings Installation Instructions contdAE,WARNING Water PipingPpe Temperature-Pressure Relief ValveVenting Filling the Water HeaterGas Piping Venting contdContd GAS Piping with Flexible ConnectorAwarning Sediment TrapInstallation Checklist Before Lighting the PilotModel Rating Plate Lighting Operating InstructionsCheck for Leaks Before Lighting Propane LP. GAS WaterWhatto Doif Yousmellgas Operating Instructions contdControlsystemand any gas controlwhichhas been underwater Not ForceHOT-Is a thermostat setting of approximately Temperature RegulationHotter Water can SCALDWater heatersareintendedto Canscaldand permanentlyinjureyouuponcontact.SomepeoTank Sediment Cleaning Service and AdjustmentBurner Cleaning Burner InspectionService and Adjustment contd Temperature-Pressure ReliefDrain Valve Washer Replacement Start Up Conditions Troubleshooting GuideCondensation Thermal ExpansionStrange Sounds Troubleshooting Guide contdAIR in HOT Water Faucets Smelly WaterContd High Temperature Shut OFF SystemNot Enough or no HOT Water Water is TOO HOTAcaution Leakage CheckpointsParts Order List Parts Order List contd Warranty 8OO-4.MY-HOMELightingpilot

153.33429, 153.33439, 153.33449, 153.33459 specifications

The Kenmore 153 series offers a range of powerful and versatile upright vacuums, specifically models 153.33439, 153.33459, 153.33429, and 153.33449. Each model presents unique features that cater to diverse cleaning needs, making them appealing choices for households seeking efficient cleaning solutions.

All models in the Kenmore 153 series are equipped with a robust motor that delivers strong suction power, allowing them to pick up dirt, debris, and pet hair with ease. The high-performance design ensures that even embedded dirt in carpets is effectively removed. Additionally, these vacuums come with a multi-surface cleaning capability, making them suitable for various floor types, including carpets, hardwoods, and tiles.

One of the standout technologies in the Kenmore 153 series is the advanced filtration system. Each vacuum is fitted with a HEPA filter that captures 99.97% of dust and allergens as small as 0.3 microns. This feature is particularly advantageous for allergy sufferers, ensuring cleaner air and a healthier living environment.

The vacuums also boast a user-friendly design, featuring a lightweight body that enhances maneuverability. The swivel steering allows users to navigate around furniture easily, while the telescoping wand extends for reach in hard-to-access areas, such as ceilings and corners. The convenient dusting brush and upholstery tool make the cleaning process seamless, ensuring no corner of the home is left untouched.

Another attractive aspect of the Kenmore 153 series is their noise-reduction technologies. The "quiet mode" feature allows for efficient cleaning without disturbing the household, making them ideal for any time of day, whether it's during nap times or late at night.

The sturdy construction of these vacuums ensures durability and longevity, paired with a sleek modern design that fits well within any home aesthetic. Each model offers adjustable height settings, allowing users to adapt the vacuum according to their cleaning preferences and the type of flooring being cleaned.

In summary, the Kenmore 153 series, featuring models 153.33439, 153.33459, 153.33429, and 153.33449, exemplifies versatility, power, and user-centric design. With their advanced technologies and robust features, these vacuums are well-suited for households looking to maintain cleanliness and improve indoor air quality. The Kenmore 153 series is worth considering for anyone in the market for a reliable vacuum cleaner.
Top Page Image Contents