Kenmore 153.33459, 153.33449, 153.33439, 153.33429 owner manual Safety Precautions

Page 4

Safety Precautions

&WARNING

The water heater with draft hood installed must be prep-

erly vented to a chimney which terminates outdoors. Never operate the water heater unless_t _svented to the

outdoors and has adequate air supply to avoid risks of mproper operat on, expos on or asphyxation.

&WARNING

Minimum clearancesbetween the water heater and com- bustible or non-combustible construction are I" at the sidesand rear, 4" at the front, and 6" from the vent pipe.

Clearance from the top of the jacket is 18" on most mod- els. Note that a lesserdimension may be al owed on some models. Refer to the label on the water heater adjacent to the gascontrol valvefor all clearances.

I

&WARNING

l

 

Do not use this appli_of

It has been under _

water. Immediately call a Sears Service Technician to I inspectthe applianceand to replace the gascontrol or any /

part of the burner systemwhich hasbeen under water.

&WARNING

HYDROGEN GAS: Hydrogen gascan be producedin a hot water system that has not been used for a long period of time (generally two weeks or more). Hydrogen gas is extremely flammable and explosive.To prevent the possi- bility of injury under these conditions, we recommend the hot water faucet be opened for several minutes at the

kitchen sink before any electrical appliances which a.re connected to the hot water system am used (suchas a dls-

hwesher or washing machine). If hydrogen gas is present, there will probably be an unusual sound similar to air

escaping through the pipe as the hot water faucet is opened. There must be no smoking or open flame near the faucet at the time it isopen.

&WARNING

INSULATING JACKETS: When installing an external water heater InsulationJacketon a gaswater heater:

DO NOT cover the temperature-pressure relief valve.

DO NOT put Insulation over any part of the top of the gaswater heater.

DO NOT put insulation over the gascontrol valve or gas control valve/burner cover, or any access areas to the burner.

DO NOT let insulation around the gas water heater to get within 8 inches of the floor (air must get to the burner).

DO NOT cover or remove operating instructions, and safety related warning labelsand materials affixed to the water heater.

Failure to heed this will result in the possibilityof a Ere or

&CAUTION

WATER HEATERS EVENTUALLY LEAK: Installation of the water heater must be accomplished in such a manner that if the tank or any connections shouldleak, the flow of water will not cause damage to the structure. When such locations cannot be avoided, a suitable drain pan should be installed under the water heater, Drain pans are avail- i able at your local Sears store. Such a drain pan must be

not greater than I _ inchesdeep, have a minimum length and width of at least 2 inches greater than the water heater dimensions and must be piped to an adequate drain. The pan must not restrict combustion air flow. Under no circumstances is the manufacturer or Sears to

be held liable for any water damage in connection with this water heater,

explosion.

Image 4
Contents For Your Safety What to do if YOU Smell GASModel No Odorant is Added to the GAS Used by this Inat E R HeaterWater Heaters Equipped for ONE Type GAS Safety PrecautionsDEATH, Serious Bodily INJURY, or Property Safety Precautions Safety Precautions Contents Specifications ProductCustomer RespOnsibilities @ 90F RiseMaterials Needed Materials and Basic Tools NeededBasic Tools Removing the Old Water Heater Installation InstructionsCut with a hacksaw approximately Facts to Consider About Location Installation Instructions contdDEATH,SERIOUSBODILYINJUR,OR Propertydamage Installation Instructions contd ALL AIR from Inside BuildingsWater Piping AE,WARNINGTemperature-Pressure Relief Valve PpeFilling the Water Heater VentingVenting contd Gas PipingGAS Piping with Flexible Connector ContdAwarning Sediment TrapBefore Lighting the Pilot Installation ChecklistModel Rating Plate Operating Instructions LightingCheck for Leaks Before Lighting Propane LP. GAS WaterOperating Instructions contd Whatto Doif YousmellgasControlsystemand any gas controlwhichhas been underwater Not ForceTemperature Regulation HOT-Is a thermostat setting of approximatelyHotter Water can SCALDWater heatersareintendedto Canscaldand permanentlyinjureyouuponcontact.SomepeoService and Adjustment Tank Sediment CleaningBurner Cleaning Burner InspectionTemperature-Pressure Relief Service and Adjustment contdDrain Valve Washer Replacement Troubleshooting Guide Start Up ConditionsCondensation Thermal ExpansionTroubleshooting Guide contd Strange SoundsAIR in HOT Water Faucets Smelly WaterHigh Temperature Shut OFF System ContdNot Enough or no HOT Water Water is TOO HOTLeakage Checkpoints AcautionParts Order List Parts Order List contd 8OO-4.MY-HOME WarrantyLightingpilot

153.33429, 153.33439, 153.33449, 153.33459 specifications

The Kenmore 153 series offers a range of powerful and versatile upright vacuums, specifically models 153.33439, 153.33459, 153.33429, and 153.33449. Each model presents unique features that cater to diverse cleaning needs, making them appealing choices for households seeking efficient cleaning solutions.

All models in the Kenmore 153 series are equipped with a robust motor that delivers strong suction power, allowing them to pick up dirt, debris, and pet hair with ease. The high-performance design ensures that even embedded dirt in carpets is effectively removed. Additionally, these vacuums come with a multi-surface cleaning capability, making them suitable for various floor types, including carpets, hardwoods, and tiles.

One of the standout technologies in the Kenmore 153 series is the advanced filtration system. Each vacuum is fitted with a HEPA filter that captures 99.97% of dust and allergens as small as 0.3 microns. This feature is particularly advantageous for allergy sufferers, ensuring cleaner air and a healthier living environment.

The vacuums also boast a user-friendly design, featuring a lightweight body that enhances maneuverability. The swivel steering allows users to navigate around furniture easily, while the telescoping wand extends for reach in hard-to-access areas, such as ceilings and corners. The convenient dusting brush and upholstery tool make the cleaning process seamless, ensuring no corner of the home is left untouched.

Another attractive aspect of the Kenmore 153 series is their noise-reduction technologies. The "quiet mode" feature allows for efficient cleaning without disturbing the household, making them ideal for any time of day, whether it's during nap times or late at night.

The sturdy construction of these vacuums ensures durability and longevity, paired with a sleek modern design that fits well within any home aesthetic. Each model offers adjustable height settings, allowing users to adapt the vacuum according to their cleaning preferences and the type of flooring being cleaned.

In summary, the Kenmore 153 series, featuring models 153.33439, 153.33459, 153.33429, and 153.33449, exemplifies versatility, power, and user-centric design. With their advanced technologies and robust features, these vacuums are well-suited for households looking to maintain cleanliness and improve indoor air quality. The Kenmore 153 series is worth considering for anyone in the market for a reliable vacuum cleaner.