Kenmore 153.330401 owner manual Service and Adjustment contd

Page 21

Service and Adjustment (cont'd)

Draining

The water heater should be drained if being shut down during freezing temperatures. Also periodic draining and cleaning of sediment from the tank may be necessary.

Turn the gas control knob to the "OFF" position. CLOSE the cold water inlet valve to the water heater.

•OPEN a nearby hot water faucet and leave open to allow for draining.

•Connect a hose to the drain valve and terminate to an adequate drain.

•OPEN the water heater drain valve to allow for tank

draining.

NOTF_ If the water heater is going to be shut down and drained for an extended period, the drain valve should be left open with hose connected allowing water to terminate to an adequate drain.

•Close thedrain valve.

•Follow instructions in the "Filling The Water Heater" section.

•Follow the lighting instructions in the "Lighting" section to restart the water heater.

Temperature-Pressure Relief

Valve Operation

The temperature-pressure relief valve must be manually operated at least once a year.

TEMPERATURE-PRESSURE

REL; VALVE

DISCHARGE PIPE

Failure to install and maintain a new properly listed tempera- ture-pressure relief valve will release the manufacturer from any claim which might result from excessive temperature or pressure.

AWARNING

If the temperature-pressure relief valve on the appliance weepsor dischargesperiodically, this may be due to thermal

expansion. Your water heater may have a check valve installedin the water line or a water meter with a check

valve. Consultthe SearsServiceCenter for further informa- tion. Do not plugthe temperature-pressurereliefvalve.

_,WARNING

When checking the temperature-pressure relief valve opera_ tion, make sure that (I) no one is in front of or around the outlet of the t_mperatu_-pressum relief valve discharge line, and (2) that the water manually discharged will not cause any property damage becanse the water may be extremely hot.

If after manually operating the valve, it fails to completely reset and continues to release water, immediately close the

cold water inlet to the water heater, follow the draining instructions, and replace the temperature-pressure relief valve with a new one.

Drain Valve Washer

Replacement

NOTE: For replacement, use a _%2" x :_'." x ¼" thick washer available at your nearest hardware store. For ordering replace- ment washers, refer to the "Parts Order List" section.

TurnFollow_OFF""Draining"gas supplyinstructionsto water. heater.

Turning counter clockwise, remove the hex cap below the screw handle.

Remove the washer and put the new one in place.

Screw the handle and cap assembly back into the drain valve and retighten using a wrench. DO NOT OVER TIGHTEN.

• Follow instructions in the "Filling The Water Heater"

section.

Check for leaks.

Follow the lighting instructions in the "Lighting" section to restart the water heater.

"_AND CAP

ASSEMBLY

WASHER

Housekeeping

Vacuum around base of water heater for dust, dirt, and lint on a regular basis.

Combustible materials such as clothing, cleaning materials, or

flammable liquids, etc. must not be placed against or adjacent to the water heater.

To insure sufficient ventilation and combustion air supply, prop- er clearances from the water heater must be maintained at all times.

Service

Before calling for repair service, read the Start Up Conditions

and Operational Conditions found in the Troubleshooting Guide of this manual.

If a condition persists or you are uncertain about the operation of the water heater, let a qualified person check it out.

Contact SEARS Repair Services at 1-800-4-MY-HOME

(1-800-469-4663).

21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents What to do if YOU Smell GAS AN Odorant is Added to the GAS Used by this Water HeaterArning Safety PrecautionsSerious Bodily INJURY,OR Property Damage Acaution AwarningContents Customer Responsibilities Product SpecificationsMaterials Needed Materials and Basic Tools NeededBasic Tools Tubing Cutters or HacksawInstallation Instructions Removing the Old Water HeaterWater passingouve Installation Instructions contd Facts to Consider About LocationDEATH,SERIOUSBODILYINJUR,ORPROPERTYDAMAGE ALL AIR from Inside Buildings Installation Completed Using Sears Installation KIT Installation Instructions contdWater Piping Hotterwater can SCALD.Water heatersam intendedtoReliefvalveopening Temperature-Pressure Relief ValveVenting Filling the Water HeaterNever usethis water heatunlessit mcompletelyfilledwith ISCREV¢DRAFTHOODIVent Pipe Installation Gas PipingVenting contd GAS Piping with Flexible Connector Installation InstructionsContd Sediment TrapContd Installation ChecklistCheck for Leaks Before Lighting the PilotOperating Instructions LightingBeforelighting PROPANEL.RGAS Water Heaters Whattodo if Yousmellgas Operating Instructions contdNot Force ForceOperating Instructions contd Temperature RegulationTank Sediment Cleaning Service and AdjustmentBurner Cleaning Venting System InspectionService and Adjustment contd Start Up Conditions Troubleshooting GuideCondensation SMOKE/ODORAIR in HOT Water Faucets Troubleshooting Guide contdCold Wateheat Smelly WaterOperational Conditions contd High Temperature Shut OFF SystemNot Enough or no HOT Water Water is TOO HOTLeakage Checkpoints Parts Order List Power Misertm 10 GAS Water HeatersModel Numbers Parts Order List contdWarranty

153.330401 specifications

The Kenmore 153.330401 is a highly regarded air conditioner that combines efficient cooling capabilities with user-friendly features, making it an ideal choice for homeowners seeking comfort during the heat of summer. This window-mounted air conditioning unit is designed to deliver powerful cooling while also minimizing energy consumption.

One of the standout features of the Kenmore 153.330401 is its impressive cooling capacity, measured at 10,000 BTU, which allows it to effectively cool spaces of up to approximately 450 square feet. This makes it suitable for medium to large rooms, such as living rooms, bedrooms, or even small office spaces. The air conditioner is equipped with multiple cooling settings, allowing users to tailor the cooling experience to their preferences.

The Kenmore 153.330401 also features an energy-saving mode that enhances its efficiency. This function helps to reduce electricity costs by automatically adjusting the cooling output based on the ambient temperature and the set preferences. The unit is ENERGY STAR certified, which ensures that it meets strict energy efficiency guidelines set by the Environmental Protection Agency.

Another notable technology integrated into the Kenmore 153.330401 is its quiet operation. This air conditioning unit is engineered to minimize noise during operation, ensuring a peaceful and comfortable environment, which is particularly valuable for bedrooms or quiet spaces. The unit also comes equipped with a remote control for added convenience, allowing users to adjust settings from across the room without having to get up.

The Kenmore 153.330401 includes adjustable air vents and a programmable timer, enabling users to set specific cooling schedules based on their daily routines. Additionally, the unit features a washable and reusable air filter, which helps to improve indoor air quality by trapping dust and allergens, and can be easily maintained for long-term performance.

In summary, the Kenmore 153.330401 air conditioner is a versatile and efficient cooling solution that offers robust performance, user-focused features, and energy-saving technologies. Whether for a living room, bedroom, or home office, this air conditioner provides a reliable option for maintaining a comfortable indoor environment during the hottest months of the year. Its combination of power, efficiency, and convenience makes it an excellent choice for any household.
Top Page Image Contents