Kenmore 153.330401 Troubleshooting Guide contd, AIR in HOT Water Faucets, Cold Wateheat

Page 23

Troubleshooting Guide (cont'd)

HOT

COLD WATE_HEAT_

O)

 

COLD WATER

pRESSURE

 

INLET FITTING

REDUCING

 

 

VALVE

 

 

BY-PASS

 

(t)

 

 

EXPANSION

 

 

TANK

 

_)

PRESSUREGAUGE INLET C

WATER

SHUTOFF

RECOMMENDED INSTALLATION

(VERTICAL MOUNTING)

Operational Conditions

SMELLY WATER

In each glasslined water heater there is installed at least one anode rod (see parts section) for corrosion protection of the tank. Certain water conditions will cause a reaction between this

rod and the water. The most common complaint assodated with the anode rod is one of a rotten egg smell. This odor is derived

from hydrogen sulfide gas dissolved in the water. The smell is the result offuur factors which must all be present for the odor to develop:

a.a concentration of sulfate in the supply warer.

b.little or no dissolved oxygen in the water.

c.a sulfate reducing bacteria within the water heater. - (This harmless bacteria is non-.toxic to humans.)

d.an excess of active hydrogen in the tank. This is caused by the corrosion protective action of the anode.

Smelly water may be eliminated or reduced in some water heater models by replacing the anode(s) with one of less active material,

WATER HEATER

FLOOR,CEIUNG

COLD WATER

JOLT,ETC.

INLET FITTING

 

HOT

COLD

STRAPPING

o)

PRESSURE

REDUCING INLET COLD

VALVE WITH WATER

O)BY-PASS SHUTOFF

EXIPANSION

(2)

PRESSUREGAUGE

ALTERNATE RECOMMENDED

INSTALLATION

(HORIZONTAL MOUNTING)

and then chlorinating the water heater tank and all hot water lines. Contact Sears Service for further information concerning

an Anode Replacement Kit #9001453 and this Chlorination Treatment.

lfthe smelly water persists after the anode replacement and chlo- rination treatment, we can only suggest that continuous chlori- nation and filtering conditioning equipment be considered to

eliminate the water pmblem.

Do not remove the anode leaving the tank unprotected. By doing so, all warranty on the water heater tank is voided.

"AIR" IN HOT WATER FAUCETS

AWARNING

HYDROGEN GAS: Hydrogen gas can be produced in a hot water system that has not been used for a long period of time (generally two weeks or more). Hydrogen gas is extremely flammable and explosive. To prevent the possibility of injury under these conditions, we recommend the hot water faucet be opened for several minutes at the kitchen sink before any electrical applianceswhich are connected to the hot water sys- tem are used (such as a dishwasher or washing machine). If

STRANGE SOUNDS

Possible noises due to expansion and contraction of some metal parts during periods of heat-up and cool-down do not represent harmful or dangerous conditions.

Condensation causes sizzling and popping with the burner area

during heating and coolin_ periods and should be considered

normal. See "Condensation section.

hydrogengas is present, there will probably be an unusual

soundsimilarto air escapingthrough the pipeasthe hot water faucet is opened. There must be no smoking or open flame

near the lancet at the time it is open.

23

Image 23
Contents What to do if YOU Smell GAS AN Odorant is Added to the GAS Used by this Water HeaterArning Safety PrecautionsSerious Bodily INJURY,OR Property Damage Acaution AwarningContents Customer Responsibilities Product SpecificationsTubing Cutters or Hacksaw Materials and Basic Tools NeededMaterials Needed Basic ToolsWater passingouve Installation InstructionsRemoving the Old Water Heater DEATH,SERIOUSBODILYINJUR,ORPROPERTYDAMAGE Installation Instructions contdFacts to Consider About Location ALL AIR from Inside Buildings Hotterwater can SCALD.Water heatersam intendedto Installation Instructions contdInstallation Completed Using Sears Installation KIT Water PipingReliefvalveopening Temperature-Pressure Relief ValveISCREV¢DRAFTHOODI Filling the Water HeaterVenting Never usethis water heatunlessit mcompletelyfilledwithVenting contd Vent Pipe InstallationGas Piping Sediment Trap Installation InstructionsGAS Piping with Flexible Connector ContdBefore Lighting the Pilot Installation ChecklistContd Check for LeaksBeforelighting PROPANEL.RGAS Water Heaters Operating InstructionsLighting Force Operating Instructions contdWhattodo if Yousmellgas Not ForceOperating Instructions contd Temperature RegulationVenting System Inspection Service and AdjustmentTank Sediment Cleaning Burner CleaningService and Adjustment contd SMOKE/ODOR Troubleshooting GuideStart Up Conditions CondensationSmelly Water Troubleshooting Guide contdAIR in HOT Water Faucets Cold WateheatWater is TOO HOT High Temperature Shut OFF SystemOperational Conditions contd Not Enough or no HOT WaterLeakage Checkpoints Parts Order List Power Misertm 10 GAS Water HeatersModel Numbers Parts Order List contdWarranty

153.330401 specifications

The Kenmore 153.330401 is a highly regarded air conditioner that combines efficient cooling capabilities with user-friendly features, making it an ideal choice for homeowners seeking comfort during the heat of summer. This window-mounted air conditioning unit is designed to deliver powerful cooling while also minimizing energy consumption.

One of the standout features of the Kenmore 153.330401 is its impressive cooling capacity, measured at 10,000 BTU, which allows it to effectively cool spaces of up to approximately 450 square feet. This makes it suitable for medium to large rooms, such as living rooms, bedrooms, or even small office spaces. The air conditioner is equipped with multiple cooling settings, allowing users to tailor the cooling experience to their preferences.

The Kenmore 153.330401 also features an energy-saving mode that enhances its efficiency. This function helps to reduce electricity costs by automatically adjusting the cooling output based on the ambient temperature and the set preferences. The unit is ENERGY STAR certified, which ensures that it meets strict energy efficiency guidelines set by the Environmental Protection Agency.

Another notable technology integrated into the Kenmore 153.330401 is its quiet operation. This air conditioning unit is engineered to minimize noise during operation, ensuring a peaceful and comfortable environment, which is particularly valuable for bedrooms or quiet spaces. The unit also comes equipped with a remote control for added convenience, allowing users to adjust settings from across the room without having to get up.

The Kenmore 153.330401 includes adjustable air vents and a programmable timer, enabling users to set specific cooling schedules based on their daily routines. Additionally, the unit features a washable and reusable air filter, which helps to improve indoor air quality by trapping dust and allergens, and can be easily maintained for long-term performance.

In summary, the Kenmore 153.330401 air conditioner is a versatile and efficient cooling solution that offers robust performance, user-focused features, and energy-saving technologies. Whether for a living room, bedroom, or home office, this air conditioner provides a reliable option for maintaining a comfortable indoor environment during the hottest months of the year. Its combination of power, efficiency, and convenience makes it an excellent choice for any household.