To Replace Dust BIN | Kenmore 116.31721 guide

TO REPLACE DUST BIN:

Turn This Direction	Open
To Close For Usage	(For Emptying)

Closed

(For Usage)

Replace dust bin lid assembly by placing back on dust bin with the marks on the lid

aligned as shown under cpen (For Emptying) on the back of the dust bin,

Rotate lid clockwise while pressing down- ward so marks align as shown above Close

(For Usage).

Check secondary filter frequently and clean when dirty.

Place		dust bin		_l\_
back into vacuum			ll,;am
cleaner		by insert-	__,_
ing	the	bottom first	/_]_'_Lv	tl 1_
and	tilt	back with	f _//_,_[-]l	_i
the dust bin han-			---/_	\_ _ltll

Dust Bin	Lower the		dust
	bin	handle	to lock
Release
	dust	bin in place.
Handle --

Dust

Bin--

Secondary

WARNING

Electrical Shock Hazard

Do not operate the cleaner without the motor safety filter. Be sure the filter is properly installed to prevent motor failure and/or electrical shock.

Always unplug power cord from electrical outlet before performing any service on vacuum.

SECONDARY FILTER

FOAM

Remove the dust bin as outlined in the DUST BIN CLEANING section.

Remove secondary filter from vacuum cleaner,

Wash the secondary filter in warm soapy water, rinse and dry thoroughly by squeez- ing the filter in your hand and letting it air dry.

DO NOT wash in the dishwasher,

DO NOT install damp.

Replace dry secondary filter. Ensure filter is properly installed over filter opening.

Replace the dust bin as outined in the DUST BtN CLEANING section.