Kenmore 116.31721 owner manual Cord Assembly, Attachment Assembly

Page 6

CAUTION

Do not overtighten.

Overtightening could strip the screw holes.

Do not operate the cleaner without the screw in place.

Using a screwdriver,

tighten the screw,

CORD ASSEMBLY

Make sure the quick release cord hook is in

the upright position, Remove the wire tie

from the power cord.

Lock the cord into

	place by forcing	it
	into the locking
	notch on the body
	of the quick	Notch
	of the quick
	release cord hook
	as shown° This
	helps keep the
	power cord out
	from under the
	vacuum cleaner
	agitator,
		Wrap the
		power cord
		around the
	Quick Release	quick release
	Quick Release	cord hook
	Cord Hook.-..	cord hook
		and lower
	Power	cord	retainer,
	Power	then	lock the
		then	lock the

power cord

	Lower Cord	plug onto the
	Retainer.,..
		power cord.

ATTACHMENT

ASSEMBLY

After the handle has been assembled to the body and the power cord has been wrapped around the cord hooks, the attachments can be assembled.

1.Snap the suction inlet end of the hose into the back of the vacuum cleaner.

2.Place the hose behind the handle and over the hose holder_

3.Place the hose in the front slot of the tool holder, twisting and pushing down over the short hose to assure a good connection.

4.Place the extension wand in the rear slot of the tool holder,

5.Slide the crevice tool into the slot beside the wand.

6.Place the dusting brush or combination brush on the wand with the brush portion up.

Handle]

Hose

HoMer

Dusting

Brush

Extension

Wand

®

Suction

InletTool

Tool

Holdei

Hose

Image 6

Contents Vacuum Cleaner Part No. CO1ZBJBODUOO-8191917Requesting Assistance Or Service Limited ONE Year Warranty on Kenmore Vacuum CleanerOperating Do not Care when2O-40600 AttachmentsCanada Belt 20-5275 20-40096Handle Assembly Cord Assembly Attachment AssemblySome Models To select a pile height settingSuggested Pile Height Settings Models with two 2 positionsHandle Release Pedal To USE Attachments To Store AttachmentsExtension Hose Some ModelsBetween Furniture Cushions* Drapes Motor Protection Performance IndicatorTo correct Problem StairsStore Cleaner To Empty Dust BIN To Clean PRE-FILTERTo Remove Dust BIN Every time dust bin is removed, rotate Dust bin at leastCheck secondary filter frequently and clean when dirty Do not wash in the dishwasher Do not install dampTo Replace Dust BIN Grasp filter handle and lift out Primary FilterExhaust Filter TridgeTo Remove BELT/CLEAN Agitator To Remove Nozzle CoverModerate To Replace BeltHeavy LightChanging InletCAuTI0 Rounding plastic partsTo Replace Agitator Belt Changing and Agitator CleaningAgitator Cleaning To Check AgitatorCleaner picks up Www,sears,corn