MOTOR SAFETY FILTER CHANGING | ] |
WARNING
Electrical Shock Hazard
Turn off and unplug vacuum cleaner
from electrical outlet, Do not operate the vacuum cleaner without the motor
safety filter, Be sure the filter is dry and
properly installed to prevent motor failure and/or electrical shock,
........ ,,,,,,,,,,,,,, | , | , | , | , | , | , |
MOTOR SAFETY FILTER ELECTROSTATIC
This filter must be replaced when dirty.. It
should be replaced regularly depending on use conditions. The filter CANNOT be
washed as it will lose its dust trapping ability.
NOTE: See PARTS AND FEATURES for Motor Safety Filter number.
1.Remove the bag as outlined in the BAG CHANGING section,,
2, Lift the rubber retainer and pull out motor safety filter as shown.,
3. Replace the filter, white side out, facing the dust bag, by sliding it back into place under the ribs in the bag cavity, Tuck filter in so
that it fits completely under the rubber
retainer.
4.Replace the bag as outlined in the BAG CHANGING section°
EXHAUST FILTER CHANGING
........................................, | , | , , | , | , |
WARNING
Fire and!or Electrical Shock Hazard
Filter
Do not operate with a clogged exhaust filter or without the exhaust filter or exhaust filter cover installed°
I
2. Pull the exhaust
filter up and out from the rear of the canister°
EXHAUST FILTER
HEPA
The exhaust filter cartridge must be replaced when dirty. Replace the filter when the entire surface area is covered evenly° The filter CANNOT be washed as it will lose its dust trapping ability.
NOTE: See PARTS AND FEATURES for Exhaust Flter number,
1.Pull out and
up on the exhaust filter cover to remove from the
canister and lay aside.
3.Replace the exhaust filter
cartridge° Place the new filter into the canister with the foam seal
facing towards the canister,
Tabs
Filter
4, Replace the exhaust filter cover
by placing the two tabs on the filter cover into the slots on the canister and rotate into place until it snaps closed,,
16