Kenmore 116.28615 owner manual To Replace Belt, Light Bulb Changing, Features

TO REPLACE BELT

!.install new belt over

motor drive, then over

belt path°Motor Drive

NOTE: See

PARTS ANDPath

FEATURES

Agitator End Cap

for Belt hum- hero

2, Place agitator

assembly back into PowerMate.

3.Line up front of cover and base, Rest cover on

front edge of base as shown.

CoverBase

		4, Rotate cover
	i {_-	back,,	Press
	_._	cover	firmly until
	_	side	and	rear
		latches		snap
Side	Rear	into place,
Latch	Latches

Make sure there is no gap between the cover and base°

5.Turn PowerMate upside down and replace two (2) cover screws,

I

LIGHT BULB CHANGING 1

1.Remove PowerMate cover as shown in

BELT CHANGING AND AGITATOR CLEANING section,

2.Push in and turn bulb counterclock-

wise, then pull out to remove,,

--'-'_Push	in l!	3. Push in and		turn
._,/-&,_'_:___		replace,	Bulb	must
And	Turn L-_	bulb clockwise,		to
		15 Watts(	130 Volts)°
		not be higher		than

4.Reinstall PowerMate cover as shown in

BELT CHANGING AND AGITATOR CLEANING section,

NOTE: See PARTS AND FEATURES for bulb number,,

18