Alwaysfollowall safetyprecautionswhenperformingmaintenanceto thePowerMate,
WARNING
Electrical Shock Or Personal Injury Hazard
Disconnect electrical supply before performing maintenance to the vacuum cleaner. Failure to do so could result in electrical shock or personal injury from vacuum cleaner suddenly starting.
BELT CHANGING AND AGITATOR CLEANING
TO REMOVE BELT
t. Turn PowerMate
upside down.
2. Unscrew the
two (2) PowerMate cover screws.
3."Parn PowerMate right
side | up, Press |
|
| ||
handle release |
|
| |||
pedal | and | lower |
|
| |
the swivel. | Lift |
|
| ||
rear | latches up. | Side | R ear | ||
Latch | Latches | ||||
|
|
|
TO CLEAN AGITATOR:
NOTE: In order to keep cleaning efficien- cy high and to prevent damage to your vacuum cleaner, theagitator must be cleaned every time the belt is changed.
The agitator must also be cleaned accord- ing to the following schedule:
Vacuum | Cleaner Use | Clean | Agitator | |
HEAVY | - |
| every | week |
(used | daily) |
|
| |
MODERATE | - | every | month | |
(used | times/week) |
|
| |
LIGHT | - |
| every | 2 months |
(used | 1 timetweek) |
|
|
IMPORTANT
grasp the sides and 4o To remove cover,
pull out.
Disconnect vacuum cleaner from electrical outlet. Check and remove hair,
string and lint
Remove any dirt or debris in the belt path area or in the brush roller area,
Carefully remove any string or debris located on the agitator or end caps,
AGITATOR ASSEMBLY
5.Lift agitator assembly out and remove
worn belt. | / | End Cap |
| _ End | Cap |
6.Check and clean end cap areas. See AGITATOR ASSEMBLY for picture of complete agitator assembly.
Brush Unit
End Cap _
17