Heat & Glo LifeStyle 8000TVD manual Installers Guide, What to do if you smell gas

Page 1

Model:

Installers Guide

8000TVD

Underwriters

Laboratories Listed

WARNING: IF THE INFORMATION IN THESE INSTRUCTIONS IS NOT FOLLOWED EXACTLY, A FIRE OR EXPLOSION MAY RESULT CAUS- ING PROPERTY DAMAGE, PER- SONAL INJURY, OR DEATH.

- Do not store or use gasoline or other flam- mable vapors and liquids in the vicinity of this or any other appliance.

-What to do if you smell gas

Do not try to light any appliance.

Do not touch any electrical switch.

Do not use any phone in your building.

Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

If you cannot reach your gas supplier, call the fire department.

-Installation and service must be performed by a qualified installer, service agency, or the gas supplier.

READ THIS MANUAL BEFORE INSTALLING OR OPERATING THIS APPLIANCE. THIS INSTALLERS GUIDE MUST BE LEFT WITH APPLIANCE FOR FUTURE REFERENCE.

WARNING: IMPROPER INSTALLA- TION, ADJUSTMENT, ALTERATION, SERVICE OR MAINTENANCE CAN CAUSE INJURY OR PROPERTY DAM- AGE. REFER TO THIS MANUAL. FOR ASSISTANCE OR ADDITIONAL INFOR- MATION CONSULT A QUALIFIED IN- STALLER, SERVICE AGENCY, OR THE GAS SUPPLIER.

Please contact your Heat-N-Glo dealer for any questions or concerns. For the number of your nearest Heat-N-Glo dealer, please call 1-888-427-3973.

Printed in U.S.A. Copyright 2004,

Heat-N-Glo, a brand of Hearth & Home Technologies Inc. 20802 Kensington Boulevard, Lakeville, MN 55044

This product is covered by one or more of the following patents: (United States) 4,112,913; 4,408,594; 4,422,426; 4,424,792; 4,520,791; 4,793,322; 4,852,548; 4,875,464; 5,000,162; 5,016,609; 5,076,254 5,191,877; 5,218,953; 5,328,356; 5,429,495; 5,452,708; 5,542,407; 5,613,487; (Australia) 543790; 586383; (Canada) 1,123,296; 1,297,746; 2,195,264; (Mexico) 97-0457; (New Zealand) 200265; or other U.S. and foreign patents pending.

379-900I 1/04

1

Image 1
Contents What to do if you smell gas Installers GuideSafety and Warning Information Table of Contents Log Set Assembly Service PartsCommon Parts / Piéces Communes Standing Pilot Ignition Valve Assembly 8000TVD-IPI Intermittent Pilot Ignition Valve AssemblyHigh Altitude Installations Installation Codes1Approvals Codes Appliance Certification2Getting Started Pre-install PreparationIntroducing the Heat-N-Glo Gas Fireplaces Unit with damaged, incomplete, or substitute partsDiagram of 8000TVD Locating the Fireplace 3Installing the FireplaceFraming the Fireplace Negative Pressure Make-up Air Installing Optional Outside Make-up AirAir Damper System Components Installing the Vent System Vent System ApprovalsRise to RUN Ratio = Maximum NO. Of Elbows 2 90o or 4 45oPositioning, Leveling, and Securing the Fireplace Vice Must be Wired to the Fireplace Junction BOXGas Control Systems Roof PitchGas Pressure Requirements Gas Supply LinePressure Natural Gas Propane Standing PilotFor Standing Pilot Ignition Wiring Appliance Requirements Wiring the FireplaceWall Switch Optional AccessoriesOperation using Battery Power For Intermittent Pilot Ignition IPI Wiring Volt TransformerFinishing Installing Trim, Logs, and Ember MaterialDouble-check for faulty components After the InstallationBefore Lighting the Fireplace Lighting the FireplaceMaintaining and Servicing Your Fireplace Fireplace MaintenanceImportant Turn OFF the GAS Before Servicing Your Fireplace