Heat & Glo LifeStyle 8000TVD manual Wiring the Fireplace, Wall Switch, Optional Accessories

	BLACK L1	BLACK L2
		HI-TEMP LIMIT SWITCH
		REMOTE SWITCH
GAS VALVE		PIGTAIL
		ON
		OFF
	WHITE T2	ON/OFF SWITCH
	RED T1
	THERMOPILE
THERMOCOUPLE	BLACK S1	OPTIONAL WALL SWITCH,
Figure 10. Standing Pilot Ignition Wiring Diagram		THERMOSTAT OR REMOTE

Step 9. Wiring the Fireplace

NOTE: Electrical wiring must be installed by a licensed electrician.

CAUTION: DISCONNECT REMOTE CONTROLS IF AB- SENT FOR EXTENDED TIME PERIODS. THIS WILL PRE- VENT ACCIDENTAL FIREPLACE OPERATION.

For Standing Pilot Ignition Wiring

Appliance Requirements

• This appliance DOES NOT require 110-120 VAC to operate.

Wall Switch

Position the wall switch in the desired position on a wall. Run a maximum of 25 feet (7.8 m) or less length of 18 A.W.G. minimum wire and connect it to the fireplace ON/ OFF switch pigtails.

WARNING: DO NOT CONNECT 110-120 VAC

!TO THE WALL SWITCH OR THE CONTROL VALVE WILL BE DESTROYED.

WARNING: DO NOT CONNECT 110-120 VAC

!TO THE GAS CONTROL VALVE OR THE AP- PLIANCE WILL MALFUNCTION AND THE VALVE WILL BE DESTROYED.

Optional Accessories

Optional fan and remote control kits require that 110-120 VAC be wired to the factory installed junction box before the fireplace is permanently installed.

CAUTION: LABEL ALL WIRES PRIOR TO DISCONNEC- TION WHEN SERVICING CONTROLS. WIRING ERRORS CAN CAUSE IMPROPER AND DANGEROUS OPERATION. VERIFY PROPER OPERATION AFTER SERVICING.

BLK

BLK

BLK

TEMPERATURE SENSOR SWITCH

VARIABLE SPEED CONTROL

BLK

JUNCTION BOX

BLK
	BLK
BLK
WHT	WHT
BLK
GROUND
GRN
BLK	WHT
110-120 VAC

NOTE: IF ANY OF THE ORIGINAL WIRE AS SUPPLIED WITH THE APPLIANCE MUST BE REPLACED, IT MUST BE REPLACED WITH TYPE 105 OC RATED WIRE.

BLOWER RECEPTACLE

BLOWER

JUNCTION BOX

FAN

TEMPERATURE SENSOR SWITCH

SPEED CONTROL

(RHEOSTAT)

Figure 11. Fan Wiring Diagram

16