Heat & Glo LifeStyle AT-GRAND-D Step Before Lighting the Appliance, Step Lighting the Appliance

Page 26

Installing the Insert (continued)

Installation (suite)

Step 9

Before Lighting the Appliance

Before lighting the appliance, do the following:

Review safety warnings and cautions

Read the Safety and Warning Information section at the beginning of this Installers Guide.

Double-check for gas leaks

Before lighting the appliance, double-check the unit for possible gas leaks.

Double-check vent terminations and front grilles for obstructions.

Before lighting the appliance, double-check the unit for possible obstructions that could be blocking the vent terminations or the front grilles.

Double-check for faulty components

Any component that is found to be faulty MUST BE replaced with an approved component. Tampering with the appliance components is DANGEROUS and voids all warranties.

A small amount of air will be in the gas supply lines. When first lighting the appliance, it will take a few minutes for the lines to purge themselves of this air. Once the purging is complete, the appliance will light and will operate normally.

Subsequent lightings of the appliance will not require this purging of air from the gas supply lines, unless the gas valve has been turned to the OFF position, in which case the air would have to be purged.

NOTE: The fireplace should be run for 8 hours on the initial start-up. This will help to cure the chemicals used in the paint and logs.

Step 10

Lighting the Appliance

You’ve reviewed all safety warnings, you’ve checked the appliance for gas leaks, you know the vent system is unobstructed, and you’ve checked for faulty components. Now you’re ready to light the appliance.

WARNING: PLEASE REFER TO THE USER’S ! MANUAL FOR ALL CAUTIONS, SAFETY AND WARNING INFORMATION PERTAINING TO THE LIGHTING AND OPERATION OF THE APPLI-

ANCE.

After the Installation

LEAVE THIS INSTALLATION MANUAL WITH THE APPLIANCE FOR FUTURE REFERENCE.

Étape 9

Avant l’allumage

Avant d’allumer l’appareil de chauffage au gaz, ne pas oublier de:

Relire et assimiler les consignes de sécurité

Relire la section Consignes de sécurité au début de ce Guide d’installation.

Vérifier qu’il n’y a pas de fuites de gaz.

Avant d’allumer l’appareil de chauffage, s’assurer qu’il n’y a pas de fuites de gaz.

Vérifier qu’il n’y a pas d’obstructions au niveau de la mitre et des grilles frontales.

Avant d’allumer l’appareil de chauffage, s’assurer qu’il n’y a pas d’obstructions dans le système de ventilation au niveau de la mitre et des grilles frontales.

Vérifier qu’il n’y a pas d’éléments défectueux.

Tout pièce défectueux DOIT ÊTRE remplacée par une pièce homologuée. Toute modification des éléments de l’appareil de chauffage est DANGEREUSE et annule toutes les garanties.

La conduite d’alimentation en gaz contient une petite quantité d’air. Lors du premier allumage, attendre quelques minutes pour que la tuyauterie se purge d’elle-même de cet air. Une fois la purge terminée, l’appareil de chauffage s’allume et fonctionne normalement.

Par la suite, il est inutile de purger la tuyauterie à chaque allumage, à moins que la vanne de commande n’ait été FERMÉE. Dans ce cas-là, purger à nouveau la conduite.

REMARQUE : Vous devez faire fonctionner le foyer pendant 8 heures la première fois que vous l’allumez. Cela permet de mieux éliminer les produits chimiques utilisés dans la peinture et les bûches.

Étape 10 Allumage

Une fois les consignes de sécurité revues, l’absence de fuites de gaz vérifiée, l’absence d’obstruction dans le système de ventilation confirmée, les éléments inspectés, l’appareil de chauffage au gaz peut être allumée.

ATTENTION: VOIR LE GUIDE D’INSTALLATION ! POUR LES CONSIGNES DE SÉCURITÉ ET LES AVERTISSEMENTS RELATIFS À L’ALLUMAGE

ET AU FONCTIONNEMENT DE L’APPAREIL.

Après l’installation

LAISSER CE GUIDE D’INSTALLATION À PROXIMITÉ DE L’APPAREIL POUR POUVOIR LE CONSULTER EN CAS DE BESOIN.

26

Image 26
Contents Guide d’installation Safety and Warning Information Page Table of Contents Service Parts Log Set AssemblyAccessories / Accessoires Homologations et codes 1Approvals and CodesApproval Listing and Codes Approvals and Codes Homologations et codes suite ARD Pre-installation Preparation Avant l’installationANY Such Action MAY Possibly Cause a Fire HAZ CES Situations Peuvent Créer DES RisquesGetting Started Mise en marche suite Diagram of the AT-GRAND-D Étape Installation du système de ventilation Installing the InsertStep Installing the Vent System Raccordement du conduit de ventilation Connecting the Vent PipeVent System Approvals HomologationsMinimum Height from Roof to Lowest Discharge Opening Installing the Insert Installing the Insert Installation suite Allumage par veilleuse DE Commande SUR 110-120 VCAStanding Pilot Ignition System Gas Controls SystemsApproved and/or licensed as required by the locality Step Gas Supply LineÉtape 4 Raccordement au gaz Fuites DE GAZ Avec UNE Flamme NUEPressure Natural Gas Propane Step Gas Pressure RequirementsÉtape Spécifications relatives La pression du gaz Pression Gaz naturel PropaneAdvertissement NE PAS Raccorder LA GAS Control Valve orTout Fonctionne Normalement Step Installing Logs and Ember Material Étape Pose des bûches et des braisesLift the top trim door up Glass Assembly Porte en verrePlacement Pose des braises Ember Material Déposer la porteRemarque Déposer L’ENCADREMENT Frontal DE Chauffage Avant D’INSTALLER L’ENCADREMENTAvertissement Lors DE LA Finition DE LA Porte ET LA Porte EN Verre DE L’APPAREIL DEMARCHE/ARRÊT Step Before Lighting the Appliance After the InstallationAprès l’installation Step Lighting the ApplianceReplacing old ember material Remplacement des braises usagéesMaintaining 4Servicing Your Appliance Entretien et révision Checking Flame Patterns, Flame HeightWhen it is hot and do not use Cleaning Glass DoorAttempt to clean the door Abrasive cleaners

AT-GRAND-D specifications

The Heat & Glo LifeStyle AT-GRAND-D is an impressive gas fireplace that combines advanced technology with contemporary design. This innovative product caters to homeowners seeking both aesthetic appeal and functional warmth, making it suitable for a variety of living spaces.

One of the standout features of the AT-GRAND-D is its expansive viewing area, providing an unobstructed view of the flames. The large glass front enhances the ambiance of any room while maximizing the visual impact of the fire. The fireplace is designed to fit seamlessly into modern and traditional decor, thanks to its diverse finishing options and customizable installation features.

The AT-GRAND-D incorporates advanced technology to enhance efficiency and comfort. One notable technology is the IntelliFire™ ignition system, which offers reliable and easy start-ups. This system ensures that the fireplace ignites quickly at the push of a button, eliminating the hassle of manual lighting. Additionally, it features an optional remote control that allows users to adjust the flame height and heat output, providing the ultimate convenience.

Safety is also a priority in the design of the AT-GRAND-D. It includes a safety screen that prevents accidental contact with the glass, ensuring peace of mind for families with children and pets. The unit is equipped with a temperature sensor, allowing it to automatically adjust the flame to maintain a comfortable environment and prevent overheating.

Another key characteristic of the Heat & Glo LifeStyle AT-GRAND-D is its impressive heat output. With a powerful BTU range, it is capable of effectively heating large areas, making it an excellent heating solution for open-concept living spaces or cozy nooks. Additionally, the fireplace is designed for energy efficiency, providing warmth while minimizing energy consumption.

The AT-GRAND-D offers customizable installation options, including the ability to use it as a built-in unit or as a standalone model with a sleek surround. This adaptability allows homeowners to create a unique focal point in their home that suits their specific needs and style preferences.

In summary, the Heat & Glo LifeStyle AT-GRAND-D gas fireplace is a top-tier option for those looking to enhance their living space with warmth and elegance. Its combination of cutting-edge technology, safety features, and stylish design makes it an excellent choice for any modern home.