Terminal Caps

BW36 SERIES WOODBURNING FIREPLACE

No one builds a better fire

REMOVE (4) SCREWS

AND LIFT TOP

PAN OFF.

LIFT UP TO

REMOVE.

SCREW SCREW

CAP

1. REMOVE THE

4 SCREWS.

2. REMOVE SCREEN.

SLIP SECTION

CAP

CHASE

3. REMOVE BAFFLE.

TR342, TR344	ST375	TS345
ROUND TERMINAL CAPS	SQUARE	SQUARE
	TERMINAL CAP	TERMINAL CAP

Figure 25

WARNING!

A CHIMNEY FIRE CAN PERMA-

NENTLY DAMAGE YOUR CHIMNEY SYSTEM. THIS DAMAGE CAN ONLY BE REPAIRED BY REPLACING THE DAMAGED COMPONENT PARTS. CHIMNEY FIRES ARE NOT COV- ERED BY THE LIMITED WARRANTY AND BUYER PROTECTION PLAN.

CAUTION:

WHEN LEFT CLOSED WHILE BURNING YOUR FIREPLACE, FIRE- SCREENS AND GLASS DOORS WILL BE HOT. HANDLE WITH CARE.

CLEAR SPACE NEAR FIREPLACE. The hearth extension must extend at least 16 inches to the front and 8” to the sides of the firebox opening for the BW36 Series fireplace. Combustible materials must not be stored in this area. Combustible walls perpen- dicular to the front of the fireplace must be at least 12 inches from the fireplace opening. Room furnishings such as drapes, curtains, chairs, or other com- bustibles must be at least 4 feet from the open front of the fireplace.

GRATE. The factory installed integral grate must be used to hold the logs from falling out of an open fire- place and to allow air to pass between the burning logs. It is important to keep the fire off the hearth and to allow the ashes to collect beneath the fire, thereby forming a layer of additional heat protection. See Figure 23, page 21. Use only model number GR16 integral grate for replacement.

NEGATIVE AIR PRESSURE WITHIN THE STRUC- TURE. This fireplace will operate correctly only if adequate ventilation is provided to allow proper draft to the fireplace system. Heat-N-Glo assumes no responsibility for the improper performance of the fireplace system caused by inadequate draft due to environmental conditions, downdrafts, tight sealing construction of the structure, or mechanical exhaust- ing devices which create a negative air pressure with- in the structure where the fireplace is located.

OUTSIDE AIR. A damper control handle allows the individual control of the outside air inlets if your fire- place is equipped with this option. Use of outside air for combustion is highly recommended to conserve heated air within the structure and to provide make up air to keep the fireplace venting properly.

4-00

30491D