Heat & Glo LifeStyle BW36 operating instructions Operating Instructions, Installing a Terminal Cap

No one builds a better fire

BW36 SERIES WOODBURNING FIREPLACE

18"

MAX.

DISTANCE

TR342

TERMINAL CAP

CHASE TOP

UPPERMOST

CHIMNEY

SECTION

It is extremely important that the fire be super- vised whenever the fireplace is in use. It is also recommended that an annual inspection be per- formed on the fireplace system to determine if the flue system needs to be cleaned, or as in the case of any appliance, if minor repairs are required to maintain the system in top operating condition.

INTENDED USAGE. This factory-built fire- place is intended for use with either solid fuel (firewood) or a decorative gas appliance that has been tested and listed to the Standard for Decorative Gas Appliances for Installation in Vented Fireplaces, ANSI Z21.60. When oper- ating your fireplace, the flue damper must be in the open position.

Figure 22

Installing a Terminal Cap

H.OPERATING INSTRUCTIONS

NOTICE:

SAVE AND PASS THESE OPERATING

INSTRUCTIONS AND THE INSTALLATION

INSTRUCTIONS TO SUBSEQUENT

OWNERS. THE INFORMATION

PROVIDED IS INTENDED TO NOTIFY

AND WARN THEM ABOUT MAKING

UNSAFE FUTURE MODIFICATIONS SUCH

AS THE ADDITION OF SHELVES OR THE

USE OF UNAUTHORIZED PARTS AND

REPAIRS.

CAUTION:

EDGES ARE SHARP! HAND PRO-

TECTION IS RECOMMENDED.

This fireplace is intended to operate as a supplemen- tal heat source for a single room. It is not designed to function as a primary heat source.

Fireplaces, as well as other woodburning appliances, have been used safely for many years. It has been our experience that most problems are caused by improper installation and operation of the unit. Make certain that installation and operation of the fireplace system is in accordance with these instructions.

4-00 20

This fireplace was not tested and listed for use with an unvented gas log heater. Do not install an unvented gas log heater in this fireplace and operate it with the flue damper in the full closed position unless the unvented gas log has been specifically tested and listed for use in this fire- place by Underwriters Laboratories Inc. Use of an unvented gas log heater in this factory-build fireplace may create a fire hazard that can result in a structure fire.

WARNING!

DO NOT OPERATE THIS FIREPLACE WITH THE FLUE DAMPER IN THE CLOSED POSI- TION. COMBUSTION PRODUCTS MUST VENT UP THE CHIMNEY SYSTEM TO PRE- VENT CARBON MONOXIDE POISONING, AND TO PREVENT HOT COMBUSTION GASES FROM CONTACTING AND OVER- HEATING COMBUSTIBLE SURFACES. FAILURE TO OPERATE THIS FIREPLACE WITH THE DAMPER IN THE OPEN POSI- TION MAY RESULT IN ASPHYXIATION OR A STRUCTURE FIRE.

CAUTION:

FIREPLACE OPERATION DOES RE- QUIRE AIR. DO NOT TAKE AIR FROM OTHER FUEL BURNING APPLIANCES WHICH CAN RESULT IN IMPROPER VENTING (SMOKING) OR AIR DILUTION. ALWAYS PRO- VIDE ADEQUATE MAKE-UP AIR.

30491D