Heat & Glo LifeStyle 6000TV-OAK 1Approvals and Codes, Appliance Certification, Installation Codes

Page 8

1Approvals and Codes

Appliance Certification

The Heat & Glo fireplace models discussed in this Installers Guide have been tested to certification standards and listed by the applicable laboratories.

Certification

MODEL: 6000TV-OAK

LABORATORY: Underwriters Laboratories

TYPE: Vented Gas Fireplace

STANDARD: ANSI Z21.50•CGA2.2

Installation Codes

The fireplace installation must conform to local codes. Before installing the fireplace, consult the local building code agency to ensure that you are in compliance with all applicable codes, including permits and inspections.

In the absence of local codes, the fireplace installation must conform to the National Fuel Gas Code ANSI Z223.1 (in the United States) or the CAN/CGA-B149 Installation Codes (in Canada). The appliance must be electrically grounded in accordance with local codes or, in the absence of local codes with the National Electric Code ANSI/NFPA No. 70 (in the United States), or to the CSA C22.1 Canadian Electric Code (in Canada).

These models (natural gas and propane) can be installed in a bedroom (in the United States) which has a total volume of unconfined space appropriate to the particular installation. Refer to the National Fuel Gas Code ANSI Z223.1/NFPA54

(current edition). The Uniform Mechanical Code - (current edition), and local Building Officials for the options allowed in obtaining an effective bedroom volume of unconfined space.

These models (natural gas and propane) can be installed in a bedroom (in Canada) if a thermostat (Model WH-STAT) is installed with the unit. Consult local code authorities. Detailed installation instructions for Model WH-STAT are included with the kit.

High Altitude Installations

U.L. Listed gas appliances are tested and approved without requiring changes for elevations from 0 to 2,000 feet in the U. S. A. and in Canada.

When installing this appliance at an elevation above 2,000 feet, it may be necessary to decrease the input rating by changing the existing burner orifice to a smaller size. Input rate should be reduced by 4% for each 1000 feet above a 2000 foot elevation in the U.S.A. or 10% for elevations between 2000 and 4500 feet in Canada. If the heating value of the gas has been reduced, these rules do not apply. To identify the proper orifice size, check with the local gas utility.

If installing this appliance at an elevation above 4,500 feet (in Canada), check with local authorities.

Heat & Glo Quality Systems registered by SGS ICS

8

Heat & Glo • 6000TV-OAK, 6000TV-OAK-IPI384-900 Rev. N • 11/05

Image 8
Contents Installation and Operation What to do if you smell gasSafety and Warning Information Table of Contents Service Parts Log Set AssemblyService Parts List 6000TV-OAK, 6000TV-OAK-IPIValve Assembly Intermittent Pilot Ignition6000TV-OAK Standing Pilot IgnitionInstallation Codes High Altitude Installations1Approvals and Codes Appliance CertificationPre-install Preparation 2Getting StartedIntroducing the Heat & Glo Gas Fireplaces ANY Such Action MAY Possibly Cause a Fire HazardDiagram of the 6000TV-OAK 3Installing the Fireplace Constructing the ChaseLocating the Fireplace Clearance RequirementsFraming Dimensions Installing Optional Outside Make-up AirFraming the Fireplace Negative Pressure Make-up AirInstalling the Vent System A. Vent System Approvals System ComponentsRise to RUN Ratio = Maximum NO. Of Elbows 2 90o or 4 45oVice Must be Wired to the Fireplace Junction BOX Positioning, Leveling, and Securing the FireplaceGas Control Systems Roof PitchGas Supply Line Gas Pressure RequirementsPressure Natural Gas Propane Standing PilotWiring the Fireplace For Standing Pilot Ignition Wiring Appliance RequirementsOptional Accessories Wall SwitchFor Intermittent Pilot Ignition IPI Wiring Volt Transformer Operation using Battery PowerInstalling Trim, Logs and Ember Material FinishingAfter the Installation Double-check for faulty componentsBefore Lighting the Fireplace Lighting the FireplaceImportant Turn OFF the GAS Before Servicing Your Fireplace Fireplace Maintenance4Maintaining and Servicing Your Fireplace