UNVENTED NATURAL GAS LOG HEATER
INSTALLATION
Continued
INSTALLING LOGS (American Oak Design Models)
WARNING: Failure to posi- tion the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal in- jury.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Slide rear log (#1) into place behind rear burner (see Figure 17).
2.Slide front log (#2) into place behind front burner. Make sure tabs at bottom of log are behind front burner (see Fig- ure 18).
3.Place crossover log (#3) into place (see Figure 19). Be sure to place back of crossover log into notch on left side of rear log. The indentation under front right fork of crossover log must rest on rectangular knob of front log.
4.Place left front branch (#4) and right front branch (#5) (24" and 30" mod- els) or front branch (#4) (18" model) into place (see Figure 20). Make sure notches on bottom rest on grates.
5.Add lava rock around base of heater.
Rear Log (#1)
Figure 17 - Installing Rear Log
Crossover
Log (#3)
Figure 19 - Installing Crossover Log
Front Log (#1L)
Front Log (#1R)
Notch
Grate
Prongs
Metal Grate Bar
Figure 21 - Installing Front Logs (#1L and #1R)
Front Log (#2)
Tab
Figure 18 - Installing Front Log
Left Front Branch (#4) (24" & 30" models) or Front Branch (#4)
(18" Model) Notches
Right Front
Branch (#5)
Notches
Figure 20 - Installing Left Front Branch and Right Front Branch
Continued
12 | 103426 |