Fireplace Installation
Continued
Installing logs, lava rock and glowing embers
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs sup- plied with fireplace.
Open louvers, remove screen, unlock door latches, and open glass door. See steps 1 and 2 of Removing/Replacing Glass Door, page 18. Install logs according to instructions for fireplace model numbers.
1.Place log #1 (base log) onto pin on left side of burner as shown in Figure 40.
2.Rest left side of log #2 (front log) onto top of log #1. Place right side of log onto second pin located on right side of grate (see Figure 42).
3.Place logs #3 (rear log) onto pin on rear of grate as shown in Figure 41.
4.Place log #4 (crossover log) onto pins from both logs #2 and #3 as shown in Figure 43.
5.Place log #5 (top log) onto right pin of front log (#2) and smooth surface of crossover log (#4) as shown in Figure 44. Make sure it is seated properly.
6.Place log #6 (left log) onto left pin of front log (#2) and smooth surface of rear log (#3) as shown in Figure 45. Make sure it is seated properly.
7.Place log #7 onto right pin of top log (#5) as shown in Figure 45. Make sure it is seated properly.
8.Place lava rock along sides and front of firebox bottom in areas that are visible only. It is not necessary to use all of the lava rock provided.
1 | 2 |
| |
Figure 40 - Installing Log | Figure 41 - Installing Log |
No. 1 | No. 2 |
3 | 4 |
|
Figure 42 - Installing Log | Figure 43 - Installing Log |
No. 3 | No. 4 |
NOTICE: Do not put lava rock on burner or under burner. Placing lava rock on burner will cause performance problems.
9.Pull ember material apart into pieces no larger than a dime. Place these pieces loosely and sparingly directly onto exposed section of front burner and along space between burner and grate prongs (see Figure 46). This will create a glowing ember appearance as the flame touches ember material. Do not block air slots by using too much ember material in one area. It is not necessary to use all of the ember material provided.
10.Close glass door, lock door latches, replace screen and close louvers (see Removing/Replacing Glass Door, steps 5 through 7 on page 19.
WARNING: The glass door must be securely in place before running this fireplace. Do not run this fireplace if glass is missing or broken.
5 | 6 | 7 |
| ||
|
|
Figure 44 - Installing Log | Figure 45 - Installing Logs |
No. 5 | No. 6 and No. 7 |
Ember Material
Figure 46 - Placing Ember Material on Burner
WALL SWITCH INSTALLATION
The installation of a wall switch allows you to activate the gas control valve and turn the fireplace on and off. The wall switch is to be connected to the incoming 120 volt regular household wiring that supplies the electricity to the fireplace. See Wiring Diagram on page 21.
optional Remote control
INSTALLATION (model WRC)
Note: If using optional wireless
1.Open lower louver panel of firebox.
2.The WRC model receiver does not require a battery. The receiver can be installed by first plugging the short extension cord into the fireplace receptacle. Then plug the receiver unit into the extension cord. Finally plug the ignition module plug into the receiver unit (see Figure 47, page 21).
20 | www.desatech.com |