Safety information
Continued
12.Do not use this fireplace to cook food or burn paper or other objects.
13.Do not use any solid fuels (wood, coal, paper, cardboard, etc.) in this fireplace. Use only the gas type indicated on fireplace nameplate.
14.This appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70, or the Canadian Electrical Code, CSA C22.1.
15.Do not use fireplace if any part has been exposed to or under water. Immediately call a qualified service person to arrange for replacement of the unit.
16.Do not operate fireplace if any log is broken.
17.Do not use a blower insert, heat exchanger insert, or other ac- cessory not approved for use with this fireplace.
18.Do not operate fireplace with glass door removed, cracked, or broken.
19.Provide adequate clearances around air openings.
Product Identification
Upper Louver | Flue Collar |
| |
Panel | Log Set |
|
Nailing
Flange 
Glass
Door
Assembly
Glowing
Embers
Control |
|
| |
Valve |
|
| |
Lower |
| Lava | |
Louver |
| ||
| Rock | ||
Panel ON/OFF/REMOTE | |||
Blower Switch | |||
Switch (Optional |
| ||
| (Optional | ||
Installation) | Grate | ||
Installation) | |||
| |||
| Assembly |
| |
Figure 1 - Victorian Direct-Vent Fireplace with
Electronic Ignition
Local Codes
Install and use fireplace with care. Follow all local codes. In the absence to local codes, use the current National Fuel Gas Code ANSI Z223.1/NFPA 54* (USA) or the current
*Available from:
American National Standards Institute, Inc.
1430 Broadway
New York, NY 10018
National Fire Protection Association, Inc.
Batterymarch Park
Quincy, MA 02269
Product Features
These are a few facts that can help you understand and enjoy your
•The venting system may be routed to the outside of your home in several ways. It may vent through the roof (vertical) or it may vent to an outside/exterior wall (horizontal). The vent pipe instal- lation is very important to allow for proper operation. You must follow the venting instructions very carefully for either vertical or horizontal applications.
•This fireplace may be installed in any room of your house provided all local codes and these installation instructions are followed.
•The blower requires electricity if installed and if you plan to install the blower at a later date, do not forget to wire the outlet at the bottom of the fireplace when framing.
•The electronic ignition creates spark to ignite the pilot light. It does not require any matches, batteries or any other sources of ignition to light the pilot.
•Each time you turn on your fireplace, you may notice some amount of condensation on the inside of the fireplace glass. This is normal and will disappear after
•Your
www.desatech.com |