As a freestanding unit with an ac, Side View

OWNER’S MANUAL

FIREPLACE INSTALLATION

Continued

8. Plug in blower power cord.

a. If your fireplace system is installed

as a freestanding unit with an ac-

cessory mantel, determine whether

the power cord will exit the left side

or the right side of the firebox. In-

stall one plastic bushing provided

into the 1 1/2" hole in the outer cas-

ing through which the power cord

will exit. Install the second plastic

bushing provided into the floor sup-

port bracket if exiting through the

9.Check to make sure that the power cord is completely clear of the blower wheel and that there are no other foreign ob- jects in blower wheel. Turn blower on and check for operation. Turn blower off by rotating knob fully counterclock- wise before continuing.

WARNING: Never touch the blower wheel while in operation.

10.Peel off the backing paper and stick the supplied wiring diagram decal on the firebox bottom approximately 3" to the right of the blower speed control bracket (see Figure 33).

WARNING: Failure to position the parts in accordance with sup- plied diagrams or failure to use only parts specifically approved with this heater may result in dam- age or personal injury.

11.Connect or reconnect gas supply to fire- place per Connecting Fireplace to Gas Supply on page 19 of this manual.

WARNING: A qualified ser- vice person must connect fire- place to gas supply. Follow all local codes.

right side (see Figure 33). Route

power cord through (both) plastic

bushing(s) and plug the power cord

Firebox	Firebox Back
Firebox
Bottom

into a properly grounded 3-prong

wall receptacle near the firebox.

b. If your fireplace system installation

is recessed and/or pre-wired, a

qualified installer must make all elec-

Thermal Switch

Firebox Flange Blower

trical connections for the outlet kit

included with the fireplace.

Lower Rear

Wall of

Firebox

Wrapper

Lower Louver

Blower Panel

Screws

Exhaust Port

Top

Mounting

Tab

Figure 30 - Mounting Blower to Firebox

Thermal

Switch

Bracket

Thermal Switch

Side View

Figure 31 - Locating Thermal Switch Against Back of Firebox

Speed

Control

Knob

Control Shaft

Locknut

Figure 32 - Attaching Speed Control to Firebox

Plastic

WiringBushing

Diagram

Blower Speed

Control Bracket

Figure 33 - Installing Plastic Bushing and Wiring Diagram Sticker

Continued

105981