REMOVING/REPLACING Glass Door

® BHDV34NA, PA

DIRECT-VENT FIREPLACE (NATURAL/PROPANE/LP)

FIREPLACE INSTALLATION

Continued

INSTALLING OPTIONAL WIRELESS HAND-HELD REMOTE CONTROL ACCESSORIES - GHRC AND GHRCT

NOTICE: Use only alkaline bat- teries (not included).

Installing 9-Volt Alkaline Battery into Receiver

1.Open bottom louver and locate the switch bracket on the left.

2.Unscrew the switch bracket. Lean bracket forward so you are able to ac- cess the back of the remote receiver.

3.Locate the battery clip mounted on the back of the receiver. Slide a 9-volt al- kaline battery (not included) through the clip.

4.Attach the terminal wires to the battery.

5.Remove the wire that runs from TH to TPTH from the valve (see Figure 40, page 21).

6.Connect wires from receiver to TH and TPTH on the valve (see Figure 41, page 21).

7.Replace the switch bracket.

Receiver

Terminal

Wires

Battery Clip

9-Volt Battery

Figure 44 - Attaching Alkaline Battery to Receiver

Installing 9-Volt Battery in Hand- Held Remote Control Unit

1.Remove battery cover on back of re- mote control unit.

2.Attach terminal wires to a 9-volt alka- line battery (not included). Place bat- tery into the battery housing.

3.Replace battery cover onto remote con- trol unit.

	Battery
Terminal	Cover	Remote
Terminal		Remote
Wires		Control Unit
9-Volt
Battery
		Battery
		Housing

Figure 45 - Installing Alkaline Battery in Hand-Held Remote Control Unit

You must remove glass door to install op- tional brick liners, logs, lava rock, and em- ber material.

CAUTION: Do not operate this fireplace with a broken glass door panel or without the glass door panel securely in place. For re- placement part information see Replacement Parts, page 32.

1.Remove the upper louver panel by lift- ing upward and out (see Figure 46).

2.Remove the screws from the three tabs at the top of the glass door while hold- ing door securely keeping it from fall- ing forward.

3.Grasp door by both sides and ease it upward off of the lower bracket (see Figure 47).

4.To replace glass door, follow the above instructions in reverse.

Top Louver

Panel

Figure 46 - Removing Top Louver Panel

Screw

Glass Door

Assembly

Lower Bracket for

Glass Door Assembly

Figure 47 - Removing/Replacing Glass Door

105981