OWNER’S MANUAL
INSTALLATION
Continued
INSTALLING LOGS
CAUTION: Do not remove the metal data plates attached to the heater base assembly. The data plates contain important warranty information.
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this heater may result in property damage or personal injury.
Each log is marked with a number. These numbers will help you identify the log when installing. It is very important to install these logs exactly as instructed. Do not modify logs. Only use logs supplied with heater.
1.Slide rear log (#1) into place behind rear burner. Make sure flat areas at bot- tom of log are behind rear burner (see Figure 36).
Rear Log (#1)
2 . Slide bottom mid log (#2) into place in behind front burner. Make sure tabs at bottom of log are behind front burner (see Figure 37).
3.Place front log (#3) into place in front of bottom mid log (#2) (see Figure 38). Make sure notches on bottom rest on grate prongs.
4.Finally place top log (#4) over bottom mid log (#2) by matching the notches under log (#4) with the raised blocks of log (#2) (see Figure 39).
Bottom Mid Log (#2)
2
Tab
Figure 37 - Installing Bottom Mid Log
5.Install fireplace screen by slipping notches of fireplace screen over screws on front of fireplace (see Figure 40).
WARNING: You must operate this fireplace with the fireplace screen in place. Make sure fire- place screen is in place before running fireplace.
Top Log (#4)
4 
4
Figure 39 - Installing Top Log
| 3 |
| Front Log (#3) |
| Notches |
Figure 36 - Installing Rear Log | Figure 38 - Installing Front Log |
Screws for | |
| Mounting Screen |
| Figure 40 - Installing Fireplace Screen |
103414 | 17 |