Desa LGCFTP Operating Fireplace, For Your Safety Read Before Lighting, Lighting Instructions

Page 18

Operating Fireplace

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service tech- nician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

LIGHTING

INSTRUCTIONS

WARNING:You must operate this fireplace with the fireplace screen in place. Make sure fire- place screen is installed before running fireplace.

NOTICE: During initial operation of new fireplace, burning logs will give off a paper-burning smell. Orange flame will also be present. Open window to vent smell. Operate fireplace on HI position to burn off odor. This will only last a few hours.

1.STOP! Read the safety information in column 1.

2.Make sure equipment shutoff valve is fully open.

3.Turn control knob clockwise to the OFF position.

4.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor.

If you smell gas, STOP! Follow “B” in the safety information, column 1. If you don’t smell gas, go to the next step.

5.Turn control knob counterclockwise to the PILOT position. Press in control knob for five (5) seconds (see Figure 27).

Note: You may be running this fireplace for the first time after hooking up to gas sup- ply. If so, the control knob may need to be pressed in for 30 seconds or more. This will allow air to bleed from the gas system.

•If control knob does not pop up when released, contact a qualified service person or gas supplier for repairs.

Ignitor

Control

Button

 

Knob

Figure 27 - Control Knob In The OFF

Position

18

www.desatech.com

119508-01A

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Shown with Optional Cabinet Mantel/Hearth Base Accessory Lgcftp and Lgcftn14,000 to 26,000 Btu/Hr with Thermostat Table of Contents Safety InformationSafety Information Local Codes Product InformationProvide adequate clearances around air openings Product Features AssemblyUnpacking Air For Combustion Ventilation AssemblyAssembling and Installing Trim Providing Adequate VentilationDetermining FRESH-AIR Flow for fireplace Location Confined and Unconfined SpaceDetermining if You Have a Confined or Unconfined Space Ventilation Air From Inside Building InstallationVentilation AIR Ventilation Air From OutdoorsInstallation Items Check GAS TypeLocating Fireplace Built-In Fireplace Installation Fireplace pilot and burner must be at least 18 above floorIf you have not assembled firebox, follow instructions on Check all gas connections for leaks. SeeChecking Gas Connections, Installing blower accessory GA3450TA Mantel Clearances for Built- In InstallationOptional Mantel Installation Removing Upper Louver AssemblyInstalling Blower Assembly Can cause improper and dangerReinstall valve cover shield Connecting to GAS SupplyFor Built-In Installation Extension CordAccessories, Natura LChecking GAS Connections Connecting Equipment shutoff valve to heater controlInstallation Items Needed Checking Gas ConnectionsPressure Testing Fireplace Gas Connections Correct all leaks at onceTest Pressures Equal To or Less Than Psig 3.5 kPa For Your Safety Read Before Lighting Operating FireplaceLighting Instructions To Turn OFF GAS To Appliance Manual Lighting ProcedureOperating Fireplace Thermostat Control OperationPilot Flame Pattern Cleaning MaintenanceInspecting Burner Burner Flame PatternCabinet Air PassagewaysExterior Troubleshooting Observed Problem Possible Cause RemedyTroubleshooting MaintenanceSee Cleaning and Mainte Maintenance,Gas leak. See Warning See Checking Gas ConnecTechnical Service SpecificationsService Hints Replacement PartsBrass Trim KIT GA6095 AccessoriesEquipment Shutoff Valve GA5010 THERMOSTATICALLY-CONTROLLED Blower KIT GA3450TAIllustrated Parts Breakdown Models Lgcftp and LgcftnParts List Parts Centrals 119508-01A Limited Warranty Warranty InformationKeep this Warranty VENT-FREE Compact fireplace

LGCFTN, LGCFTP specifications

Desa LGCFTP and LGCFTN are innovative technology solutions designed to cater to modern communication and data management needs. These platforms are part of a broader suite of services aimed at enhancing connectivity, streamlining data flow, and enabling seamless interaction between users and systems.

One of the main features of Desa LGCFTP is its robust file transfer capabilities. It utilizes the File Transfer Protocol (FTP) to ensure that data can be moved securely and efficiently over networks. This feature is particularly crucial for businesses that handle large amounts of data, as it allows for the quick transfer of files ranging from reports to multimedia content without compromising on security.

In addition to the FTP functionalities, Desa LGCFTN incorporates advanced networking technologies that enhance connectivity among users. This platform is designed to facilitate reliable connectivity options, enabling organizations to establish networks that can support various applications, from simple database queries to complex real-time data exchanges.

Both Desa LGCFTP and LGCFTN are built with scalability in mind. This means that as user requirements grow, these systems can easily adapt to accommodate increased data loads and more extensive user bases. The technology underpinning these platforms is based on an architecture that supports distributed processing, which is essential for ensuring that performance remains high, even as demand fluctuates.

Security is a top priority for both platforms. They implement a range of protocols and encryption techniques to safeguard data during transfers and while at rest. This commitment to security helps organizations maintain compliance with industry standards and regulations, which is increasingly important in today’s data-driven environment.

Desa LGCFTP and LGCFTN also emphasize user experience. Their intuitive interfaces make it easy for users to manage files and navigate through different features. This focus on usability reduces the learning curve, ensuring that teams can quickly leverage the full capabilities of the platforms without extensive training.

In summary, Desa LGCFTP and LGCFTN represent cutting-edge solutions in the realm of file transfer and network connectivity. With their emphasis on security, scalability, and user experience, these platforms are well-equipped to meet the challenges faced by modern businesses, making them invaluable tools for efficient data management and communication.
Top Page Image Contents