Operating Instructions, Glass Information

Brookhaven Direct Vent Gas Fireplace

Operating Instructions

Glass Information

Only glass approved by CFM Corporation should be used on this ﬁreplace.

•The use of any non-approved replacement glass will void all product warranties.

•Care must be taken to avoid breakage of the glass.

•Do not operate appliance with glass front removed, cracked or broken.

•Replacement glass (complete with gasket and window frame) is available through your CFM Corporation dealer and should only be installed by a licensed qualiﬁed service person.

Cast Front Panel

Machine	Machine
Screw	Screw

Pull Left
Side Latch
Counter-	Pull Right
clockwise	Pull Right
	Side Latch
	Clockwise

Cast Front

FP1628

Attach the cast panel by hook- ing onto top of ﬁreplace.

To remove the cast front assem- bly, pull cast front up then lift out.

Fig. 29 Remove cast front by lifting up then out.

FP1629

Fig. 30 Window frame assembly removal.

Glass Cleaning

It is necessary to clean the glass periodically. During start-up condensation, which is normal, forms on the inside of the glass and causes lint, dust and other airborne particles to cling to the glass surface. Also initial paint curing may deposit a slight ﬁlm on the glass. It is therefore recommended the glass be cleaned

two or three times with a non-ammonia household cleaner and warm water (gas ﬁreplace glass cleaner is recommended). After the initial cleaning process the glass should be cleaned two or three times during each operating season depending on the environment in the house.

Window Frame Assembly Removal

1.Turn the ﬁreplace OFF (including the pilot).

2.If the unit has been operating, allow time for the components to cool.

3.Remove cast front assembly.

4.Unlock the frame window by removing the two (2) machine screws at the top corners of the window frame.

5.Unlock the frame window by pulling the handle of the two latches at the bottom part of the window frame. Pull the left latch counterclockwise and the right latch clockwise.

6.Pull the bottom of the glass frame assembly out and slide the top of the frame assembly out the slot at the top.

7.To replace the window frame assembly, reverse this procedure.

Clean the glass after the ﬁrst two weeks of operation.

Do not clean glass when hot. Do not use abrasive cleaners. Do not strike or slam the glass.

10009459