Vermont Casting Discover the Features of the WinterWarm Small Insert
Page 3

WinterWarm Small Insert

Specifications

WinterWarm Small Insert

EPA Emissions Rating

gph, catalytic 2.1*

Range of heat output*

8,700 - 31,100 Btu/hr

Maximum heat output**

30,000 Btu/hr

Area heated***

1,000 sq. ft.

Size of wood splits

18” (460mm)

Fuel Capacity

30lbs. (13.5kg)

Loading

Front

Flue size

6” (150mm)

Fireplace Insert weight

285lbs. (130kg)

Primary Air Control

Manual/thermostatic

Secondary Air Control

Self-regulating

Glass panel

High-temperature ceramic

Flue exit position

Top

Blower rating ...............................110cfm. (115V, 60Hz)

*Under specific test conditions used during EPA emis- sions standard testing.

**This value can vary depending on how the unit is operated, and the type and moisture content of the fuel used. Figure shown is based on maximum fuel con- sumption obtained under laboratory conditions and on average efficiencies.

***These values are based on operation in building- code conforming homes under typical winter climate conditions in New England. If your home is of nonstan- dard construction (e.g. unusually well insulated, not in- sulated, built under ground, etc.) or if you live in a more severe or more temperate climate, these figures amy not apply. Since so many variables affect performance, consult your Vermont Castings’ Authorized Dealer to determine realistic expectations for your home.

16���" (420mm)

6���"

(160mm)

21���" (535mm)

13" (330mm)

6���"

(165mm)

26" (660mm)

 

25���" (650mm)

21���" (535mm)

 

21���"

(535mm)

0888

Fig. 1 WinterWarm Small Insert dimensions.

2000888

3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Winter Warm Introduction Table of ContentsWinterWarm Small Insert SpecificationsChimney Height / U.S. and Canada InstallationRequirements for Existing Fireplaces Requirements for Existing ChimneysSealing Requirements / U.S Minimum Fireplace DimensionsWhen the insert is installed in a factory-built fire- place General Considerations / U.SHearth Requirements Clearance RequirementsOptional Surround Packages Installing the WinterWarm Small InsertConnect the Blower power cord to the power supply Install the Chimney Connector Starter Pipe. Not suppliedPrimary Air Control OperationYour WinterWarm Insert’s Controls and What They Do DamperBurn Only High-Quality Wood Use the Air Control Settings that Work Best for YouWinterWarm Small Insert Control Settings FansHow To Build and Sustain a Wood Fire High-Efficiency Wood Burning with Catalytic CombustionStarting and Maintaining a Wood Fire Reloading and Reviving a Wood Fire Special Tactics for Cold-Climate HeatingDo not over-fire this heater Remove and Store Ash Safely Care of the Porcelain Enamel Surface MaintenanceCleaning the Glass Adjust the Door Latch PeriodicallyRemoving and Replacing Door Glass Adjust the Damper as NeededHow to Replace Gaskets Replacing the Insert’s Door GasketsReplaceable WinterWarm Small Insert Fiberglass Gaskets When To Suspect a Combustor Problem Care of the Catalytic CombustorRemoval and Inspection of the Combustor Refractory Package Chimney System Clean Chimney System is Safer Works Better Watch for Better ResultsLearn To Recognize Avoid Creosote Fireplace System Maintenance Schedule FireplaceFlex Connection Appendix Catalytic Combustor WinterWarm Small Insert Model WinterWarm Small Insert Warranty CFM Corporation
Top Page Image Contents