Empire Comfort Systems BVD36FP32, L)N-1, BVD34FP50, BVP42FP32 Direct Ignition Troubleshooting

Page 25

DIRECT IGNITION TROUBLESHOOTING

With proper installation and maintenance, your new Gas Fireplace will provide years of trouble-free service. If you do experience a problem, refer to the troubleshooting guide below. This guide will assist a qualified service person in the diagnosis of problems and the corrective action to be taken. Refer to page 24 for initial startup and GAS Line purge instructions.

SYMPTOM

CHECK

ACTION

No spark when system is turned to “ON”

Check for 120V between black “hot” line

If 120V not present, check fuse or circuit

and reset cycle* has been completed.

at control module and “white” return at

breaker or repair wiring leading to

 

module.

fireplace.

Spark for six (6) seconds at ignitor, but no

a. Check that gas is turned on and system

Turn gas on and/or purge system.

ignition of burner.

purged.

 

 

b. Check that tips of ignitor are directly

Position electrodes so tips are directly

 

above ports on main burner. Spark is

above burner port ports and about ¼" to

 

between electrodes and not from one

3/8" above burner.

 

electrode to burner.

 

 

c. Check for 120V at each coil on the gas

If 120V present, but gas valve does not

 

valve and listen for click, indicating gas

click, replace gas valve.

 

valve is opening.

 

Spark for six (6) seconds, main burner

Check for clean ground path between

Clean, position according to wiring diagram,

lights, but goes out when spark stops.

electrode bracket and fireplace chassis.

and repair defective electric connections. If

 

Check wiring to wiring diagram label.

all electrical connections are clean and

 

Check for broken electrode on high-tension

correct, replace module.

 

lead attachment to module.

 

Main burner lights normally and then goes

a. Check ignitor to burner gap.

Igniter should be located 1/4" to 3/8" above

out.

 

burner area.

 

b. Check high-tension lead and connector

Replace spark electrode assembly.

 

for shorts.

 

 

c. Refer to installation instructions

Repair as required.

 

troubleshooting guide for issues such

 

 

as venting.

 

DIRECT IGNITION PROPANE/LP GAS CONVERSION

The conversion shall be carried out in accordance with the requirements of the provincial authorities having jurisdiction and in accordance with the requirements of the CSA B149.2 installation code (Canada) and with the requirements of the National Fuel Gas Code Z223.1/NFPA 54 (United States).

WARNING: This conversion kit shall be installed by a qualified service agency in accordance with the manufacturer's instructions and all applicable codes and requirements of the authority having jurisdiction. If the information in this instruction is not followed exactly, a fire, explosion, or production of carbon monoxide may result causing property damage, personal injury, or loss of life. The qualified service agency is responsible for the proper installation of this kit. The installation is not proper and complete until the operation of the converted appliance is checked as specified in the manufacturer's instructions supplied with the kit.

Installer notice: Using an ink pen, fill out the required information on the conversion label. Remove the backing from label and stick label in a visible position on bottom of fireplace close to gas valve.

Installer notice: These instructions must be left with the appliance.

Instructions for converting your direct ignition fireplace from natural gas to propane/LP gas.

All direct ignition fireplaces are shipped from the factory equipped to operate on natural gas. To convert the direct ignition fireplace to operate on propane/LP gas, follow the instructions on Page

26.Please see the appropriate parts list for your model for parts included with the direct ignition fireplace.

Check the items in the kit with the parts list. Notify the supplier of any items that are missing before installing the conversion kit.

19400-3-0406

Page 25

Image 25
Contents Installation Instructions Table of Contents Appliance Important Safety InformationLP-GAS Warning Odor Safety Information for Users of LP GASIntroduction Fireplace Dimensions SpecificationsClearances Mantel Chart FigureLocating Fireplace Combustible MaterialGAS Supply Installing a New Main Gas CockGAS Line Hole Checking Manifold PressuresVent Pipe Clearance Install the Fresh Air Kit BVA1 InstallationFraming and Finishing Framing FigureFinishing Figure Combustible Surround InstallationInstalling the Vent System in a Chase General MaintenanceVenting Vent RunsNever downsize venting diameters Clearances Vent SizeVent Configuration Offset Venting With Elbows Ember Material Placement on Burner LOG Placement 5 LOG SETLOG Placement 3 LOG SET Millivolt System Operating InstructionsInitial Lighting Pilot Flame FigureFrbc Battery Operated Remote Control Wall Switch, FWS-1 optionalStanding Pilot Operating Instructions Millivolt ControlStanding Pilot Wiring Diagram What to do if YOU Smell GAS Standing Pilot Lighting InstructionsFrequent pilot outage problem Standing Pilot TroubleshootingPilot burning, no gas to burner, valve knob on Pilot and main burner extinguish while in operationStanding Pilot PROPANE/LP GAS Conversion Pilot Orifice Conversion Optional Remote Control 120V Direct Ignition Direct Ignition Wiring DiagramDirect Ignition Lighting Instructions For Your Safety Read Before LightingDirect Ignition PROPANE/LP GAS Conversion Direct Ignition TroubleshootingMaxitrol Valve Conversion Please Note Maintenance and ServiceBrick PANEL, Painted BVD34 & BVD36 Parts ListBVD34 & BVD36 Parts View Flex LINE/SHUTOFF Valve BVP42 Parts ListBVP42 Parts View FBB4 Optional Variable Speed Blower Installation Volt AC Standard Millivolt Valve Models Junction BOX Wiring Installation InstructionsBVA1 Optional AccessoriesDecorative Louver Mission Decorative Louver Arch Decorative AccessoriesService Notes HOW to Order Repair Parts Service Notes Service Notes

BVD34FP50, BVP42FP52, BVP42FP32, BVD34FP30, BVD36FP52 specifications

Empire Comfort Systems has carved a niche in the heating industry with its series of high-quality ventless gas fireplaces. Among their popular models are the BVD34FP50, BVD34FP30, BVD36FP52, BVP42FP52, and BVP42FP32. Each of these units combines sophisticated design with innovative technology, offering home comfort and style.

The BVD34FP50 and BVD34FP30 are known for their sleek appearance and efficient performance. These models feature a minimalist design that allows them to blend seamlessly into any room decor. The BVD34FP50 is equipped with a powerful 50,000 BTU output, making it ideal for larger areas. Conversely, the BVD34FP30, with its 30,000 BTU output, offers an energy-efficient heating solution for smaller spaces. Both models utilize Empire's advanced vent-free technology, which allows for easy installation without the need for traditional venting.

The BVD36FP52 stands out for its versatility in design and efficiency. With a 52,000 BTU capacity, it heats larger spaces effectively while maintaining a sleek and modern visible flame. This model also benefits from an adjustable flame feature, allowing users to customize the intensity to their liking. Its superior ceramic glass front provides excellent heat retention and delivers an unobstructed view of the mesmerizing flames, enhancing any living space.

Empire's BVP42FP52 and BVP42FP32 models further exemplify the brand’s commitment to innovation. The BVP42FP52 offers a robust heating capacity of 52,000 BTUs, while the BVP42FP32 delivers 32,000 BTUs, making both units adaptable for varying room sizes. These models are distinguished by their high-efficiency ceramic glass doors and programmable thermostats, allowing for precise temperature control.

All models are designed with user-friendly features such as remote control options, adjustable flame height, and safety shut-off mechanisms. Additionally, their contemporary aesthetics make them suitable for modern and traditional homes alike. Empire Comfort Systems ensures top-tier reliability and performance, making these fireplaces a worthy investment for all who seek warmth and elegance in their living spaces.