Installing Line for Gas Logs

CFM Corporation ﬁreplaces are designed to accept a 1/2" gas line for installation of an approved gas appli- ance. (CFM Corporation manufactures a wide variety of gas logs for use in CFM Corporation ﬁreplaces.)

Be sure to have the appliance installed in accordance with building codes.

Gas connection may enter from either left or right side of the ﬁreplace.

Locate appropriate gas line access hole in the outer casing of ﬁreplace and remove insulation from gas line tube. (Fig. 27)

From inside the ﬁreplace, locate the knockout on the ﬁrebrick -- be sure you are on the appropriate or "gas line" side of the ﬁreplace. Using a ﬂat bladed screwdriver or small chisel and hammer, carefully tap around the knockout until it loosens and falls out.

Install 1/2" certiﬁed gas pipe through opening. After gas pipe installation is complete, use insulation that was removed from gas line tube to repack space around the pipe. Material should be inserted from out- side of the ﬁreplace and packed tightly to totally seal between the pipe and tube.

NOTE: Gas pipe should not come in contact with any wood structures until it has reached a point at least one (1) inch away from ﬁreplace side.

NOTE: When installing an ANSI Z21.11.2 ventless appliance, the ﬁnishing materials used for the mantel must be rated at 250°F or greater.

BTU input of a gas appliance installed in ﬁreplace should be rated less than 100,000 BTU/Hr.

Gas pipe installation is intended for connection to a decorative gas appliance only when (1.) incorporat- ing an automatic shut-off device and (2.) complying with the Standard for Decorative Gas Appliances for Installation in Vented Fireplaces (ANSI Z21.60) or CSA draft requirements for Gas-Fired Log Lighters for Woodburning Fireplaces (Draft No. 4, August 1993).

Decorative gas appliance should be installed in accor- dance with the National Fuel Gas Code, ANSI Z223.1/ NFPA 54 (latest edition).

WMC Series Woodburning Fireplace

	Hole in Outer Casing	Fireplace Top View
		1"	Supply
	Gas Line	Min.	Supply
	Tube		Line
	Tube
	Ceramic		Repack Insula-
	Knockout		tion
			1/2"
Hole in Outer
Casing
			Ceramic Knock-
			out
			(Both sides)
			FPC560
Fig. 27	Gas line access.

CAUTION: WHEN USING DECORATIVE GAS AP- PLIANCE, FLUE DAMPER MUST BE SET IN FULLY OPEN POSITION. IF YOU HAVE GLASS DOORS ON THE FIREPLACE, THEY MUST ALSO BE FULLY OPENED.

WARNING: DO NOT OPERATE AN UNVENTED GAS LOG SET IN THIS FIREPLACE WITH THE CHIMNEY REMOVED.

WARNING: WHEN INSTALLING AN UNVENTED GAS LOG SET, THE CFM CORPORATION MODEL AH3244BK OR AH3244PB 4" ADJUSTABLE HOOD MUST BE USED.

If installing an unvented gas log set, refer to statement below:

Only unvented gas log sets which have been found to comply with the Standard for Unvented Room Heaters, ANSI Z21.11.2, are to be installed in this ﬁreplace.

20000583

Installing Line for Gas Logs

Fireplace Top View