Dimplex DF2608 owner manual Existing Fireplace

Fireplace Installation

Option #2: A new outlet can be installed inside the framing construction.

Plug the unit into a 15 Amp, 120 Volt outlet. If the cord does not reach, you may use an extension cord rated for a minimum of 1875 Watts.

Existing Fireplace

1.Seal all drafts and vents with a non-fibrous insulation material to prevent any chimney debris from falling onto the fireplace. Do

not install into an existing fireplace that is prone to dampness.

2.Cap the top of the chimney flue to prevent rain from entering.

3.Plan your electric power supply.

4.The power cord can run along the front of the hearth to an outlet near the fireplace.

CAUTION: Clearance for air circulation beneath the fireplace insert is provided by two (2) spacers. Do not install the fireplace insert directly on carpet or similar

surfaces which may restrict air circulation. If installing the fireplace in a carpeted area, place a one-piece, solid, flat surface under the fireplace insert. Ensure that all feet rest securely on this surface.

For Bathroom Use

If this unit is installed in a bath- room it must be protected by a GFI receptacle or circuit. If receptacle is used it must be readily accessible. To prevent electrical shock this unit is an electrical appliance that is not watertight and must be installed as to prevent water from entering unit. This must be installed away from showers, tubs, etc. Never locate fireplace where it may fall into a bathtub or other water con- tainer. High temperatures may be generated under certain abnormal conditions. Do not partially or fully cover or obstruct the front of this heater.

10 www.dimplex.com