Dimplex DF2608 owner manual Upper Light Bulb Requirements

Maintenance

clockwise.

12.Replace light filter bracket and flicker rod.

13.Install the log set assembly by placing the front, bottom edge of the ember bed in the track behind the control panel. Once in place, push down on the back edge of the ember bed until the rear tab snaps into place under the mirror (Figure 8).

!NOTE: Ensure the log set

Assembly is installed tightly under the bottom edge of the mirror to prevent light leakage.

14.Lay unit on it’s back and slide Front Glass back into position

and attach trim.

Upper Light Bulb Requirements

Quantity of two (2) clear chandelier or candelabra bulbs with an E-12 (small) socket base, 15 Watt rating.

Do not exceed 25 Watts per bulb.

To access the upper light bulb area:

1.Slide fireplace out of mantel.

2.Lay unit on it’s back for safe removal of front glass.

3.Remove three (3) Phillips screws from right side of trim.

4.Remove trim.

5.Slide glass to the right side

Figure 9	Light Block screws (4)
	Light Block
Flicker Rod	Light Filter
	Bracket screws (2)
	Lower Light
	Bulbs (3)
	15