Enviro Indoor Gas Fireplace Secondary Installation, Left trim is so the power cord can be

Secondary Installation

INSTALLATION OF SURROUND PANEL:

The Sienna must have one of the panels installed around the unit; the unit panel, the filler panel, or the filler panel with trim. If you have trim for your filler panel, the trim must be installed before installing the filler panel onto the unit.

1.	Attach one side trim to the top trim using a corner bracket (see Figure
	26) to secure pieces together. There are two (2) main pieces to each
	corner bracket (see Figure 27). When installing the corner pieces into
	the trim the “B FACE” sides must face each other and the screw heads
	are to face out. With the bracket in place and the top and a side trim
	snug together use a flat head screwdriver to turn the two (2) screws in
	the bracket in to tighten it into the trim.
2. Slide the two (2) attached trim pieces onto the surround panel.
3. Attach the other side trim piece to the top trim using the same method
		Figure 26: Corner brackets
	used in Step 1.
		for trim.

4.Place the second side of the trim on the surround panel in the same manner use on the first side and secure in the same manner.

5.On the side trims there are holes 2” (50 mm) from either end. Using a Phillips screwdriver to place a #8 screw 11⁄4” long in each hole and tighten (refer to Figure 28). This will keep the trim tight against the surround.

	NOTE: The notch at the bottom of the
	left trim is so the power cord can be
	run to the outside of the panel.
		Figure 28: Screw to
		hold the trim against
Figure 27: Two pieces of corner bracket.		the surround.

INSTALLATION: Lift the surround upright in front of the fireplace with the four (4) hooks pointing towards the fireplace. Slide the hooks into their corresponding slots (see Figure 29). Ensure the hooks are pushed all the way into the slots and the notch on the hook must be on the bottom of the slot. The surround should be wiped with a damp cloth periodically.

REMOVAL: Lift the surround straight up in order to unhook the notch on the hooks from the bottom of the slots. Pull the surround out away from the fireplace. Place the surround where it will not be damaged.

Figure 29: Filler panel with trim installation.

20