Cabletron Systems 9F106-01 manual Installing an Fpim

Page 15

Installing the MMAC-Plus Module

Installing an FPIM

The 9F106-01 module is shipped without FPIMs. To install an FPIM, follow the procedure below:

1.Remove the module if it is installed in the MMAC-Plus chassis.

2.Remove the blank front cover over the FPIM slot.

3.Install the FPIM as shown in Figure 2-4.Ensure that the rear connector is seated ﬁrmly before tightening the two mounting screws.

Figure 2-4. Installing an FPIM

2-6

Image 15

Contents MMAC-Plus9F106-01 Two Port Fddi Router User’s Guide Page Vcci Notice FCC NoticeDOC Notice Contents Introduction FeaturesManagement Information Base MIB Support Features Getting Help Related ManualsInstalling the MMAC-Plus Module Installing the MMAC-Plus Module Local Management Console Reset SwitchXoff Menu Function SelectionLocal Management Console Installing an Fpim Installing an FpimOperation F106-01 Block DiagramDC/DC Converter System Diagnostic ControllerFlexible Network Bus FNB System Management BusesCPU FNB InterfaceLanview LEDs Lanview LEDsLED Color State LED Color State DescriptionFunction of the Fddi Receive LED is listed in Table Safety ServiceSpeciﬁcations Environment PhysicalParameter Typical Value Worst Worst Case Budget Fpim SpeciﬁcationsPin Number Represents FPIM-02 and FPIM-04Parameter Typical Minimum Maximum FPIM-05